Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
If the hub bore is 1.5 inches like you mentioned (the area of the hub where the cap installs) then we don't have a Bearing Buddy that will fit. If the measurement was more like 1.75 inch then the #BB1781 would most likely fit as it measures…
view full answer...If both middle jacks are not retracting or extending on your #LC675817, odds are one or more of the fuses is out. There is a fuse for each of the legs and if one of these is bad, it will definitely cause the legs not to work. This can be mounted…
view full answer...I have a solution for you, but we do not have a double lip grease seal with the exact measurements you specified. However I was able to find out that the GS-1250 DL that you mentioned has the following measurements: Inside Diameter: 1.249"…
view full answer...If they were talking about the hub face and spring center measurements then what was referred to was the hub-face-to-hub-face and spring-center-to-spring-center lengths. Hub face is measured from the base of one wheel stud to the base of the wheel…
view full answer...It sounds like you are heading in the right direction. To decide where your springs seat will be you will need to mock up your trailer as if you were installing all of the equipment on it. Once you have the suspension part mocked up you will want…
view full answer...The usable length of the etrailer Pull Pin #TJP-PN916 is 3-1/2" with 3-1/8" to the center of the detent ball, as show in the attached photo. This pin is designed for use with etrailer and Ram Pipe Mount Swivel Jacks 9/16"…
view full answer...If your leaf springs are the lowest rated component on your trailer then if you were to use leaf springs with a higher weight capacity, like part #e54SR, it would increase your total weight capacity. However, it sounds like you have a 2,000 lb axle…
view full answer...Many times Dexter hubs will fit on a Lippert axle, but Lippert does have a few axles out there with special spindle sizes. Every Lippert axle comes with a tag or plate on the axle that gives a serial number or NV number. If you can give me that…
view full answer...I did some research and was unable to find the component listing for the hub assembly you referenced. The best way to find out what the components are would be to remove them and locate the numbers on the bearing and seal and race. I have attached…
view full answer...The closest option we have available to your existing round Glo-Brite assemblies (which are no longer made) is the Optronics LED Trailer Tail Light #STL13RFHXB. This assembly has an overall diameter of 5-5/8" and the light face itself…
view full answer...I feel confident that the wiring behind the Atwood #AT91230 wall panel is not correct. I would disconnect all 120 volt electric and 12-volt DC then take that panel off the wall and compare it to the wiring diagram I have attached. This should be…
view full answer...The Draw-Tite Activator IV #5504 will work with a wiring harness adapter like part #20127, for your 2009 Chevrolet Silverado. This means you will need to splice into the brake controller wiring under the driver's side dash in order to install…
view full answer...Filter Your Search
Contact and Help