Ford F-350 Super Duty Headache Rack

Hey Chris, the overall height of the Aries AdvantEdge Headache Rack #AA88VB that you referenced is 26-1/2 inches. It's not difficult to remove but wasn't designed for getting removed and installed super easily.…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

Hi David; the BringIt SwitchBack SOLO Down Tailgate Camera #BR75ZR can be used without a tailgate. You will need to mount the tilt sensor so the system thinks the tailgate is open for this to work. I would also cap off the unused connector with…

There is a quality headache rack that will work with a tonneau cover that fits inside the bed rails on your 2017 Ram 2500, but the Westin HLR Headache Rack #57-81025 would likely interfere with any tonneau. The reason for that is it installs with a…

In order to install Rhino-Rack HD bars on your 2023 GMC Sierra 1500 you'll need the following parts: - 59" HD Crossbars #RB1500B-2 - 2500 Series Legs for HD Bars #RRRLKHD - DK Fit Kit #DK427 I'm not 100% sure…

The portion of the mounting bracket of the B&W Custom Headache Rack #BWPUCP7522BA that would install to the inside of the bed rails would not interfere with your tool box. Also, the 26 inch height is the height of the tabs.

To add a gooseneck hitch to your 2024 GMC Sierra 2500 with a 6-3/4' bed, I recommend the B&W Custom Underbed Installation Kit item #BWGNRK1020. It has a massive 30,000 lbs capacity and fits both the 6-3/4' and…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

The biggest pro to using one valve stem to maintain air pressure in an air bag kit is that you always know that both bags will have an equal amount of pressure in them. If you have an application where equal pressure on both sides is always the…

The B&W Custom Headache Rack w/ LED Brake, Turn, Tail Lights #BWPUCP7500WA uses bonded 4 pole wire to make the connections, however most of the new Fords have a "smart" tow plug, which means that it is looking…

You would have no problem setting your crossover style tool box on top of the rails of the B&W Custom Headache Rack #BWPUCP7522BA that you referenced. To allow the box to open though you'll need to move it towards the rear of…