Hey Paul! You do not need a wiring extender to use the Pop & Lock Custom Tailgate Lock #PL34FR or #PL54FR. Both have enough wire to work with your 2023 Tacoma Sport long bed.
The BAKBox 2 Truck Bed Toolbox part #BAK92601 measures 10" wide so it should not interfere with the trunk lid but you want to measure the clearance between the open trunk lid and the cab to be sure. However, the BAKBox 2 attaches to BAKFlip…
Hi Gregg; the Pop & Lock Valet Conversion Kit #PL5500CONV is designed to replace an existing lock core. Since you do not have a lock on your 2013 Tacoma this will not fit. Instead, you need a replacement handle with a lock like the Pop & Lock…
Model numbers for tonneau covers can typically be found on the fabric portion of the cover on the bottom side usually towards the tailgate end. If your model number is located there then it would either be on the side rails or on the rail at the…
If the BAKFlip G2 Hard Tonneau Cover #BAK26601 was installed on your 2014 Honda Ridgeline and it was folded back you would have no interference with it and your trunk. If the G2 cover was folded down the door would open basically as tall as the…
The BAKFlip F1 Hard Tonneau Cover #BAK72601, which is a fit for your 2012 Honda Ridgeline, will be installed in the same manner as you see in the attached demonstration video. I also attached a link to the instructions which are somewhat universal…
You can get a replacement key for your #PAL6100 through Pop & Lock if you give them the number stamped into the face of the lock cylinder. If you can't get this for some reason the only option would be to get the replacement lock cylinder…
We have a locking tailgate for your 2010 Chevy Silverado 1500 with the part #PAL1310 that comes with two unique keys like what you are looking for. This way you could prevent someone with your ignition key from being able to access your tailgate.
If the locking mechanism of the Pop and Lock Powered Tailgate Lock, #PAL8320, fails, the only way to unlock the tailgate is to break into the tailgate to remove the lock. I spoke with my contact at Pop and Lock and he said most lock smiths can do…
The B-pillar is located where the driver's seat belt is stored (see photo). You will need to remove the driver's door sill trim, left rear door sill trim, door opening seal and the B-pillar lower trim cover before you can remove the B-pillar…
I have linked the installation instructions for the Pop & Lock Custom Tailgate Lock with Plug & Play T-Harness #PL34FR below. You will want to see page 7 to locate where the plug and play harness ties into the factory wiring behind the…
Yes, the Replacement Lock Core for Pop & Lock Tailgate Lock #PL5400CONV for the Pop & Lock Custom Locking Tailgate Handle - Manual #PAL5500 will work great with your 2012 Toyota Tacoma TRD Sport with a backup camera. If you check out the…
