Chevrolet C/K Series Pickup Truck Bed Rail Caps

The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV will be just fine if you need to lift your 2022 Ford F-250 Super Duty, but it will be good practice to lower the psi rating to 5 prior to lifting the truck. I confirmed this…

The pin box on your 2023 Heartland BigHorn 3970RL is a Lippert 1621. The Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY38FR will fit the bolt pattern but I'm not 100% sure it is the correct…

The BAKFlip MX4 Tonneau Cover #BAK48330 for the 2022 F-250 short bed has 4 panels. While you are using your Demco Autoslide 5th Wheel Hitch #DM8550024 you will be able to keep one panel laying flat on the bed. There are tow ways you can store the…

Thanks for the information. I checked with TruXedo and to replace just the cover on your 2012 Ford F-150's 5-1/2' bed you will need the Replacement Cover for TruXedo Lo Pro Soft,…

The head of the Demco Hijacker part #DM8550024 weighs 65 lbs. The total weight of the hitch with the head would be 289 lbs. You would need two people to get this hitch in and out.

Since you are pulling a trailer that weighs around 8,500 lbs. you would just want to stick with the Firestone Ride-Rite Air Helper Springs #F35FV (5,000 lb.). You really only need to spend more for the Firestone Ride-Rite Red Label Extreme Duty Air…

The Demco Hijacker Autoslide 5th Wheel Hitch w/ Slider - Single Jaw - Ford Super Duty Prep Package - 18K, part #DM8550024, weighs approximately 305 lbs.

When adjusting the arms of the #BWRVK3305, you have the option of setting up so the king pin will sit 3 inches forward or 1 inch forward of the axle. I'd set it up at the tallest height, 18-3/4 inches above the…

You will want the hitch to be set at the height that 1) allows the trailer to be level, and 2) allows you a minimum of 6 inches between the bottom of the trailer loft and the top of the bed rails. The fifth wheel hitches offer several inches of up…

The Underside Tie Down Point #RRS606 will fit into the tracks on the underside of a Rhino-Rack Pioneer Platform Rack like the #RR78AB. Regular tie-downs #RR43VT and eye bolts #RR46XP are also available for the top channels on the rack.

Yes, trying to couple at an angle with the Demco Hijacker Autoslide #DM8550034 is actually not recommended. The head is fairly hard to move but you should be able to get it. It'll get easier with use. One method…

There are 2 basic tie-down style accessories made for your Rhino-Rack Pioneer Platform Rack: - Eye Bolt Kit #RR43178 - Tie-Down Anchors #RR43VT The eye bolts provide more of a rigid and established point while the anchors have more of a sleek…