Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System part #LC672136 is designed for trailers with a GVWR of up to 10,000 lbs. I cant comment on fit for any specific make/model but the universal design will allow it to…
view full answer...In regards to the amount of travel that the rear jacks of the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System #LC672136 offer, 12 inches is the amount each jack can extend to offer to level your trailer. The jacks are…
view full answer...There's no reason you'd have to remove your old stabilizers when installing the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System #LC672136 unless they were in the way of where these need to install, but in…
view full answer...Yes, we have checked with Lippert in the past and their Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System #LC672136 is compatible with boxed frame RVs like your 2019 Outdoors RV Backcountry series Model 23KTS.
view full answer...In order to test the controller on the Lippert Ground Control 3.0 Electric Leveling System you'll first need to obtain a multimeter. Once you have this then you will need to use the ground probe and place that on the green wire coming from the…
view full answer...I reached out to my contact at Lippert regarding the issue you're having with the Level-Up Hydraulic System on your trailer/RV. He said the symptoms you described are likely due to a faulty touch pad, but there is one thing he wants you to check…
view full answer...Typically when the Quick Level Touch Pad #LC74FR red light flashes it indicates an error and the retract button flashing green it means that the error has been reset. The issue appears to be on the extending, so it's possible that there's…
view full answer...Wiring connections for the Electric Over Hydraulic Brake Actuator are as follows. Yellow - Cold side of breakaway switch, The wire that goes hot when a breakaway occurs. Black - Positive connection on breakaway switch, The wire that charges the…
view full answer...First thing you will need to do is check that all of the wiring of the actuator and your brake controller are correct. I attached a couple diagrams that should be helpful I spoke with my contact at Dexter and there is a way to troubleshoot your…
view full answer...If you measured the stud size on your hub and drum assembly and they measured 1/2 inch then they may work with the Dexter Trailer Hub and Drum Assembly #8-219-4UC3-EZ, which also uses 1/2 inch wheel studs. The fact they are both 1/2" does not…
view full answer...The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube…
view full answer...Yes, the autolevel feature can be used to relevel the trailer if needed. The nose of the trailer will need to be above level before you hit autolevel button on your Quick Touch keypad #LC74FR, so you'll want to ensure that you raise the front…
view full answer...Related Searches
Filter Your Search