Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Getting your trailer level shouldn’t take all afternoon. This electric landing gear set runs nearly twice as fast as the older 80-RPM base model, cutting down the time you spend holding the switch. With a total 37" lift—21" of screw travel plus 16" from the drop leg—there’s plenty of range to handle uneven ground or tall setups. When power isn’t available, the included manual hand crank keeps you moving without delay.
Each leg in this kit can take on part of a big load with ease, giving a combined capacity of 6,000 lbs. It’s made from sturdy steel and finished with a corrosion-resistant black powder coat that resists rust from road spray and rain. Large rectangular footplates—5" long by 7-15/16" wide—spread the weight over soft surfaces, keeping your trailer steady and preventing sink-in on dirt or gravel pads.
Matching new landing gear to existing frame brackets is simple thanks to standard weld stop spacing of 15-1/2" inside-to-inside (17-1/2" outside-to-outside). An extendable cross shaft adjusts from 41" to 71" so you can line the legs up perfectly across different frame widths. If your old brackets don’t match, new hardware and mounting brackets are included for a solid bolt-on or weld-on install.
The fuse-protected wiring keeps the system safe from shorts and works seamlessly with typical electrical setups. The motor is ignition protected for safe mounting near propane systems. If power cuts out, switch to the manual crank and you’re still able to raise or lower without disassembly—no need to cancel your trip over a blown fuse.
Instead of cranking endlessly, each jack uses gravity to extend its drop leg for quick ground contact before final lift. Once down, the rectangular footplates stay planted, keeping your trailer from rocking while parked or during loading and unloading. It’s a practical upgrade that turns setup from a chore into a short step before relaxing at camp.
Note: Do not use landing gear to lift your trailer or RV during tire changes or service work, because doing so will exceed the capacity of the landing gear.
Customer Satisfaction Score:
90% were satisfied with this product
10% of customers were not satisfied
Ratings & Reviews
Ernie H.
11/3/2017
Sold the trailer to my son and his family last spring. Up till that time I experienced no problems and he has not indicated any problems with the landing gear. Cant say enough about the support provided by your company to fix the original manufacture mistake of the kit having two leading legs originally sent to me. I would definitely recommend your company to my friends and family.
Edward T.
4/7/2023
Still very noisy gears but it works.
Shauna
12/8/2022
Our landing gears are doing great. We have been enjoying our tour of the states
Katrina B.
4/13/2022
I have some installation instructions in the link below.
Helpful Links
file:C:UsersKatrina.BunchDesktopGround%20Control%C2%AE%203.0%20Landing%20Gear%20Owner's%20Manual.pdf
Verified B.
6/9/2023
We have had no problems with the landing gear. After having it installed by someone it has worked perfectly ever since.
Mike L.
7/8/2023
Jenny N.
4/21/2022
I will have our Customer Service team reach out to you.
Do you have a question about this Camper Jack?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Cal
3/3/2022
After using the landing gear for over a year on several trips, the landing gear, motor, and gear box have Worked flawlessly.