Search: electric jack   >  

Hey Rick, thanks for reaching out! I'm guessing the 90" dimension is the width of your trailer door so for your application I recommend the Conventional Ramp Door Spring #M394FR because it has a 185 lb weight rating. This means…

Hey Ryan, thanks for reaching out! The only true electric trailer jack made to fit a standard boat trailer with a pole tongue is the Fulton XLT Powered Drive Trailer Jack #F141401. Even though this is the only option available, Fulton has added…

Hi Walter, For the Deka Battery Isolator #DW08770 you can go with 8 gauge wire. Deka actually makes an installation kit with this wire, the Deka Battery Isolator Installation Kit for Standard Alternators #DW08769.

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack…

Since you've already got a 4 pole on your trailer, you'd just need to add a 7-way with #ETBC7 so that you can run a charge line using #10-1-1 from the accessory circuit to your battery. This circuit is located at the 1'oclock position on…

Yes, the Heavy Duty Equalizer Suspension Kit part #K71-360-00 does fit your 2008 Weekend Warrior 300FS that has a triple axle setup and a 35 inch wheelbase.

Self-adjusting brakes #AKEBRK-7-SA do not require that you travel in reverse for them to adjust. They can adjust themselves going forward or backward. Keep in mind that even self-adjusting brakes require 1 initial adjustment. You could just install…

We have an 8 foot ramp door spring that has dual torsion springs like you asked about with the part #M394FR. This is the hand wound torsion style spring you mentioned.

A diode like the part #RM-690 is a great idea but the only issue is that is has a max load of 85 amps. A standard 5,000 lb winch, like the ComeUp DV-5000si #CU645010, will greatly exceed the 85 amp rating of the diode so it would be useless. What you…

To replace the extend/retract switch on your Lippert 181794 Electric Trailer Jack you'll simply need the Replacement Extend/Retract Switch for Lippert Electric Trailer Jack #LC49MD. If you're needing to replace the on/off or just both…

If I'm understanding you correctly the starter solenoid #PK5231201 is not the solution to your problem. Based on what you have described, it sounds like both the breakaway battery and winch battery are hooked to the 12V power coming from your…

The Curt T-Connector #C56093 is a great place to start with wiring on your 2024 Ford Explorer. To get your vehicle ready for your trailer I recommend the following parts: - Universal Installation Kit #ETBC7 - Redarc Tow-Pro Liberty Brake Controller…