Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Cory, thanks for reaching out! The Replacement Support Leg #TH33VK is for the 8-1/2" long Thule HideAway awnings which is what I believe will be a better match than the part #TH48VK you referenced, which is for a 10' long HideAway…
view full answer...To install the Small Coin Pattern Vinyl Flooring #TS97FR with the RV Flooring Adhesive #TS76FR you just need to make sure that your trailer floor is a bare wood so you have the best bonding of the adhesive as possible. Be sure to sweep it out really…
view full answer...Yes, you can swap from the 3-Leaf Slipper Spring w/ Radius End for 1,500-lb Trailer Axles - 24-5/8" Long #e99SR to the 2-Leaf Slipper Spring w/ Radius End for 1,000-lb Trailer Axles - 24-5/8" Long #e36SR to help reduce how much shock is…
view full answer...You are correct that Atwood was bought out by Lippert, and replacement parts are difficult to come by these days. I spoke to my contact at Lippert and your Atwood 66280 Level Leg system does not have any replacement parts available, so the…
view full answer...The Atwood G6A-8E water heater has 12.5" H x 16" W x 17" D dimensions and the only 10 gallon tank we currently have is the AT94022 which has 16" H x 15-1/2" W x 20-7/8" D dimensions. Since the 10 gallon tank will require…
view full answer...The Chrysler Pacifica began production with the 2017 model year, so there was no 2016 model Chrysler Pacifica. Some auto manufacturers release the next year's model in late spring or early summer of the previous year, so it's easy to mistake…
view full answer...The Tekonsha T-One Vehicle Wiring Harness #118723 is designed to work with the LX and Touring Trims of your 2020 Chrysler Pacifica. These trims do not have LED tail lights. For your Limited trim you will need either the Curt T-Connector Vehicle…
view full answer...I spoke with my contact at Lippert regarding the Electric Trailer Jack with Footplate #LC285318 referenced in your question. For this jack they recommend 26 ft lbs of torque for the hardware that will hold the jack to your trailer. This is a very…
view full answer...The correct SnapPad pads for a 9 inch round jack foot is part #SP54FR4, which includes 4 pads
view full answer...The bracket length of the Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors part #UF39-941705 is 36". It fits trailers and RVs with frames from 8" to 80" wide. The bracket length of the Ultra-Fab Power Twin II Electric…
view full answer...Advent Air Conditioners like part #ACM135 come with a connector that pairs up directly with the standard 6-wire connector. If you have a 9-wire connector then you need the kit #ACRG15 as well. For wiring I'm attaching some photos of diagrams for…
view full answer...Typically if there are two wires running from the furnace to the AC system then it means that the furnace has power already connected to it and it sends that through one of the wires up to the AC until the system calls for heat, at which point the…
view full answer...Related Searches
Filter Your Search
Contact and Help