Hey Dennis, welcome back! I have a couple of options for you depending on what you mean by flip over ball. If your 2014 Ram 2500's gooseneck ball goes into a square shaped receiver like item #BWGNRK1384, then I highly recommend the B&W…
The Hopkins Plug-In Simple Wiring Harness #33405 that you referenced is the correct harness for your 1997 Toyota Land Cruiser and is actually the same part as the 43405 model number you referenced. Sometimes we use slightly different part numbers…
Hey Larie, we have the Bauer RV Entry Door Lock part #BA53UR that you referenced which was designed to fit the standard RV door cut outs that are 3-3/4" tall x 2-3/4" wide which I would bet is correct for your Winnebago Minnie Winnie but I…
The Westlake 215/75R17.5 Radial Tire w 17-1/2" Lynx Aluminum Wheel #LHAS701 are intended for wheel bolt size 9/16-18 with an 8 on 6-1/2 inch bolt pattern. These wheels with that bolt pattern and wheel bolt size are rated for 4,805 lbs at 123…
Typically, when the outside edges of a tire are showing wear its because the tires are under-inflated. The solution is to inflate the tires to the maximum pressure listed on the sidewall. Now if the outside of tires have what looks like gouges are…
I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
Hi Roger! I contacted Dexter with your axle information and you will need the #25580 inner bearing and #14125A outer bearing. If you want the races as well, you will need the #25520 and #14276 respectively. The seal will be the Double Lip -…
I have a couple close but not perfect to your measurements. The 2" Lubed Dust Cap & Rubber Plug - 1.99" part #DC200L-DCRP is an extremely common cap size found on a lot of trailers. Sometimes the hub will have a small bevel on them that…
I understand how it would be unclear which measurement to use since the center of the axle is not the same as the center of the wheel on a torsion axle. For a single axle trailer, measure from the center of the spindle (center of wheel) to the…
The SAE number of a trailer light isn't always the best way to pick out a replacement light since that isn't a part number. But most likely you are looking for a #A32RB which measures 4 inch by 2 inch for red and part #A32AB for amber. If you…
Based both on the Bargman 84 Series part number you found and pictures I was able to pull up of your 2011 model 2619 TrailManor Camper it looks like the correct replacement tail light is the Bargman LED #47-84-540. This is a double LED light with a…
For a Lippert 4,400 lb trailer axle the correct bearing kit is the part #BK2-100 which includes inner bearing #L68149, inner race #L68111, outer bearing #L44649, outer race #L44610, grease seal #58846, a cotter pin and a tang washer.
Filters
