Replacement Brake Setup for Trailer with DB-42 Disc Brakes
Updated 07/22/2020 | Published 07/20/2020 >
Question:
Hello, My current trailer has DB-42 calipers and they are rusted and not functioning well. I am reading that its advised to replace it with the DB-35 and that Kodiak brakes are an upgrade. The rotors/hub probably could use replacement because the trailer was not well taken care of and two of the wheels have one lug broken off they are 5 lug rotors. There are two axles and both of them had calipers for four total. What parts will I need to do the full upgrade and should I be looking at replacing the brake lines at this point? Thanks
asked by: Ben A
Expert Reply:
The DB-42 is an older style of UFP 3,500 lb axle disc brake components. The Kodiak kits like the part # K2HR35D will fit in replacement of that and would be an upgrade so this would be a great solution. It comes with everything you'd need to convert to the Kodiak brakes. These are Dacromet coated too which means it'll do a great job resisting corrosion as well.
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 3500 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: db~42
- Shop: Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: Dexter Premier Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Video: Hands-On with the Dexter Premier Disc Brake Kit
- Search Results: kodiak calipers
- Search Results: kodiak brake caliper
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2
- Shop: Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Search Results: l68149
- Search Results: l44649
- Shop: Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet and Stainless - 3,500 lbs
- Shop: Kodiak Disc Brake Kit - 8" Rotor/Hub - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: DeeMaxx Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Maxx Coating - 3,500 lbs
- Q&A: Brake Kit Upgrade For A Boat Trailer With UFP DB-42 Brakes
- Search Results: trailer brakes
- Search Results: backing plate
- Q&A: Bearings and Grease Seal Recommendation for Titan Premier Disc Brake Kit # T2HRCM10DAC
- Shop: Trailer Hitch
- Video: Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers Review
- Video: Electric Over Hydraulic Disc Brake Installation - 2021 Vanleigh Beacon Fifth Wheel
- Video: Titan Master Cylinder Assembly Installation
- Q&A: Will My Ram Factory Brake Controller Work With Electric Over Hydraulic Brakes.
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Video: The Low-Down on the etrailer Rust-Resistant 4-Leaf Double Eye Spring for 5K Trailer Axles
- Q&A: What Info Is Needed to Pick Out Replacement Surge Actuator for Trailer
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Bleed Your Trailer Surge Brakes
- Video: What to Know About the Kodiak Ceramic Brake Pads
- Q&A: Correct Replacement for UFP H-1377 Trailer Hub


