Result: jack

Hey Vaughn, thanks for reaching out! What do your leaf springs measure when they don't have a load on them? You'll need to measure center-to-center for the eyes when you have the trailer lifted by the frame. Your 2007 Jayco should have…

Hello Scott, thanks for reaching out. For a 4 wheel trailer I recommend the TST TPMS System #TST-507-RV-4-C. This one comes with 4 sensors, a signal booster and a color display. You can alwasy add more sensors if you want to monitor the vehicle tires…

You are going to have to take some clearance measurements with your 145/R12 Radial Trailer Tire #AM35354 to determine if the larger Kenda Karrier ST175/80R13 Radial Trailer Tire with 13" Black Mod Wheel #AM31990 is going to fit. The 175/80-13 is…

Hi Rick, What you're referring to is a snap ring swivel plate which would require the appropriate mounting plate being welded to the jack. Instead you can use the etrailer Bolt-On Swivel Mounting Plate #e52JR to attach the Bulldog Round,…

The spindle dimensions are as follows: A is the mounting dimension, B is the seal dimension, C is the inner bearing surface, D is the outer bearing surface and E is the diameter of the threaded portion of the spindle for spindle nut selection. Say…

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

Yes, the Dexter Self-Contained Hydraulic Jack #DX72CR does come with a manual hand pump that can be used as a backup in the event of hydraulic malfunction.

You can absolutely use the Dexter 12 inch brake assemblies. If you have electric brakes then the Dexter Nev-R-Adjust Electric Trailer Brake Kit - 12" - Left and Right Hand Assemblies #23-458-459 with your current hubs. You may also want the new…

I took a walk out to our warehouse to measure these TruRyde backing plates #TRU96FR. I have attached a few pictures for your reference. The backing plate is not flat on the back, so I measured from the "deepest" part of the plate- the…

I couldn't be 100% positive about which wheel studs you'd need without seeing the trailer and being able to measure. I just don't have enough information. This bein said, by virtue of the trailer having a 5 on 4-1/2 inch wheel bolt…

I have a replacement jack option for you, but I do not recommend cutting off the footplate and drilling a hole in the tube to mount a caster like the Removable 6" Caster for 2-1/4" Trailer Jacks - Steel Caster - 1,200 lbs Item #JC-102 to…

The Sidewind Swivel Bulldog Jack, part #BD1541150301, you referenced measures 16-3/4 inches from the top of the jack to the bottom of the tube when retracted. From the top of the jack to the center of the mounting tube the distance is 9 inches. From…