Chevrolet Colorado Truck Bed Camera

After installing The Rear View Safety Rear View Mirror with Monitor #RVS-718, per the manufacturer they state that there is more then likely a possible short within the camera. They recommend to check all the connections such as the ground, and make…

Hey Larry, the Torkift Fastgun Tie Downs part #TLS9522-2-LK that you referenced would be the correct size as they have a range of 25 to 43 inches which would cover what you'd need.

Hey Thom! You're not missing anything. The RVS WIreless Hitch Camera part #RVS87FR really is as simple as you made it out to be. It is new to us and we haven't had the chance to get one in yet but once we do we will make the videos and take…

Good afternoon Nathan, that's a great question! You can use the etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers #e38FV with a 3" to 2" reducer adapter like Buyers Products 3" to 2" Receiver Tube Adapter…

No, you'll need a longer one since you have a Ford truck. The correct 4" Offset Ball for B&W Turnoverball on a 2013 Ford F-150 is item #BWGNXA4085. The 4" Offset Ball for B&W Turnoverball Gooseneck Trailer Hitch for Dodge Ram…

The Custom Third Brake Light Camera kit part #3460002 is a fit for your 2017 Ford F-250 that has the 4.2 inch screen size on the dash. We do not have a way to wire the switch to the switches you mentioned but I am sure there's a way it could be…

The Third Brake Light Camera part #3460002 that you referenced is not available without a switch, this comes with a gasket which provides the seal but also silicone sealant/butyl tape is recommended, the factory screws of your truck are long enough…

Hello Jamie, thanks for reaching out. Since your 2024 Ram 2500 is a short bed, I do recommend that you go with a sliding 5th wheel hitch. The slider is to help with clearance on tight turns or when backing up into a tight parkign spot. If your Ram…

The GCH third brake light camera for an 8 inch GM monitor that fits your 2018 Chevy Silverado 2500 is the part #3460010 and for a 7 inch monitor #3460011. The cameras are basically the same but the connectors and connections that need to get made are…

Hey Mike, thanks for reaching out! It sounds like your 2025 Toyota Sienna doesn't have any wiring at the back so you'll need to install the T-One Wiring Harness #TK69FR along with the Universal Wiring Kit #ETBC7. This will give you all of the…

Hello Rocky, thanks for reaching out. If your new leaf springs do not have as much of an arch as the old springs they are definitely not going to help your situation if your tires are already rubbing on the fenders. What we would usually do here is…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…