Install Instructions for Truck Bed Cargo Camera for 4.2" Factory Monitor # 3460002

Published 12/20/2018

Question:

I plan to use a factory accessory switch do you have a package without the switch? i have a few questions 1. do you have a package that doesnt include the switch i plan to use a factory installed switch? 2. How do you seal around the third light after you install the camera? 3. do the factory screws have to be replaced sense you are adding some material between the light and the cab? 4. does your kit include the appropriate size hot or power wire and connections? 5. Do you have any sale coming up or coupon codes. 6. If i install your camera i can switch between the factor tailgate camera and your 5th wheel camera correct? 7. Does your installation package require and factory wires to be cut or altered in any way? 8. do i have to Program anything or plug anything into the OBD2 in order to override anything?

asked by: Patrick S

Expert Reply:

The Third Brake Light Camera part # 3460002 that you referenced is not available without a switch, this comes with a gasket which provides the seal but also silicone sealant/butyl tape is recommended, the factory screws of your truck are long enough and do get reused, the length of wire included is long enough (see picture with diagram), since this tees into the factory camera harness you can use the included switch to toggle between the view of this and the tailgate camera, and finally there is not programming required to install the kit and activate everything.

expert reply by: Jameson C