Hello Louis, Congrats on the 1994, that’s a truck you can still work on, and honestly the older trucks are way cooler than the spaceships we drive around today. For your 1994 GMC 1/2 ton Sierra with a stepside bed, the Pace Edwards Full-Metal…
Hey Paul! You do not need a wiring extender to use the Pop & Lock Custom Tailgate Lock #PL34FR or #PL54FR. Both have enough wire to work with your 2023 Tacoma Sport long bed.
Hey Gino, you'll want to take a couple measurements to determine what shank you'd need from a Blue Ox Swaypro to allow your trailer to be towed level. You'll want to measure from the top of your hitch opening on your vehicle down to the…
The BAKBox 2 Truck Bed Toolbox part #BAK92601 measures 10" wide so it should not interfere with the trunk lid but you want to measure the clearance between the open trunk lid and the cab to be sure. However, the BAKBox 2 attaches to BAKFlip…
Hi Gregg; the Pop & Lock Valet Conversion Kit #PL5500CONV is designed to replace an existing lock core. Since you do not have a lock on your 2013 Tacoma this will not fit. Instead, you need a replacement handle with a lock like the Pop & Lock…
Model numbers for tonneau covers can typically be found on the fabric portion of the cover on the bottom side usually towards the tailgate end. If your model number is located there then it would either be on the side rails or on the rail at the…
The BAKFlip F1 Hard Tonneau Cover #BAK72601, which is a fit for your 2012 Honda Ridgeline, will be installed in the same manner as you see in the attached demonstration video. I also attached a link to the instructions which are somewhat universal…
Hey Jesse, cool name. It is possible to rekey the Pop & Lock Custom Locking Tailgate Handle #PAL1310 to your ignition key. For that you will need the following: - Replacement Lock Core for Pop & Lock Tailgate Lock - Manual BOLT Lock - Silver…
You can get a replacement key for your #PAL6100 through Pop & Lock if you give them the number stamped into the face of the lock cylinder. If you can't get this for some reason the only option would be to get the replacement lock cylinder…
We have a locking tailgate for your 2010 Chevy Silverado 1500 with the part #PAL1310 that comes with two unique keys like what you are looking for. This way you could prevent someone with your ignition key from being able to access your tailgate.
The B-pillar is located where the driver's seat belt is stored (see photo). You will need to remove the driver's door sill trim, left rear door sill trim, door opening seal and the B-pillar lower trim cover before you can remove the B-pillar…
If the locking mechanism of the Pop and Lock Powered Tailgate Lock, #PAL8320, fails, the only way to unlock the tailgate is to break into the tailgate to remove the lock. I spoke with my contact at Pop and Lock and he said most lock smiths can do…
