Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline

Question

Question:

When installed on the 2011Honda ridgeline does it interfere with the trunk lid from opening fully?

asked by: Robert P

0

Expert Reply:

The BAKBox 2 Truck Bed Toolbox part # BAK92601 measures 10" wide so it should not interfere with the trunk lid but you want to measure the clearance between the open trunk lid and the cab to be sure.

However, the BAKBox 2 attaches to BAKFlip tonneau cover G2 part # BAK26601, BAKFlip tonneau cover F1 part # BAK72601 or BAKFlip tonneau cover FiberMax part # BAK126601 for the 2011 Honda Ridgeline. The BAKFlip covers retain 75 to 80 percent of the total access to the trunk. Which means the rails prevent the trunk of opening past them.

expert reply by: Heather A

0

Answer 1

The BAKFlip F1 Hard Tonneau Cover #BAK72601, which is a fit for your 2012 Honda Ridgeline, will be installed in the same manner as you see in the attached demonstration video. I also attached a link to the instructions which are somewhat universal…

view full answer...

Answer 2

You can get a replacement key for your #PAL6100 through Pop & Lock if you give them the number stamped into the face of the lock cylinder. If you can't get this for some reason the only option would be to get the replacement lock cylinder…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline

Products Featured in This Question

Continue Researching