Hey Liam. All of our 10" brake assemblies like item #23-454-455 have a 4-bolt brake mounting flange. The Trailer Hub and Drum Assembly item #8-407-5UC3-EZ you were looking at is not available in a 12" drum. We do not have a 12" braking…
Hey Mario, thanks for reaching out! Congrats on your new purchase of the Ultimate Trailer Jack #322-RDJ-2K! There aren't any adapter mounts to make this so it mounts on the bracket you're pointing out in your photo, so if you want a jack to…
Hey David, thanks for reaching out! Yes, in order for the Dexter Trailer Idler Hub Assembly #8-213-5UC1-EZ to work with that axle type you'll need the Grease Seals #RG06-070. This makes it so the idler hub fits the same axle as the Hub and Drum…
The DB-42 is an older style of UFP 3,500 lb axle disc brake components. The Kodiak kits like the part #K2HR35D will fit in replacement of that and would be an upgrade so this would be a great solution. It comes with everything you'd need to…
Hey Luke! On the etrailer scissor jacks #e56VV, the closest bolt holes center-to-center are about 3-1/2" apart, while the next set of holes is 4-1/2" center-to-center. Since yours are currently 80mm apart, that translates to a little less…
Thanks so much for that info and we do have the exact hubs you need for your boat trailer. Since you have a 5-lug hub with inner bearing #L68149 and outer bearing #L44649, the correct hub is the galvanized Trailer Idler Hub Assembly - Galvanized…
Hello Joey, thanks for reaching out. We do have one hub that uses the bearing combination you are looking for. See the following: Trailer Hub and Drum Assembly - 4,400-lb E-Z Lube Axles - 10" Diameter - 6 on 5-1/2 #8-407-5UC3-EZ This has the…
The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…
The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…
I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
Filters
