Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…
view full answer...The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…
view full answer...The hub/drum you sent in a picture of is a Lippert 8,000 lb axle hub with an 8 on 6-1/2 inch bolt pattern designed for oil-bath applications. The correct replacement then is the #8-285-10UC3-A.
view full answer...It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…
view full answer...We have that size (see link), but none of the tires are radial. They are all bias ply as that is the common construction for the LT tires. The closest tire size that is radial would be the 235/80R16 like part #TTWTRTM2358016E. This size has a section…
view full answer...The seal replacement for your 22333 kbn is the Grease Seal - Double Lip #GS-2250DL. This is a direct replacement with a 2.250" inner diameter and 3.376" outer diameter.
view full answer...The Electric Jack w/ Footplate is offered both with the plug part #EJ-3527-BBX and without the plug part #EJ-3520-BBX. Therefore, if you wanted to go with the model that has the plug and just cut that off you would indeed just run the wire to the…
view full answer...I checked with Wesbar and the lens only for the LED version of the tail lights you have is not available as a separate part but you can replace the light with #271595 for the left side of the trailer and #271594 for the right side.
view full answer...If you used strong enough brackets when installing the Single Axle Trailer Fender #CE18041ATB they'd be strong enough to support people of all shapes and sizes. These don't have a specific weight capacity but they are pretty strong. Normally…
view full answer...I think you might be talking about diameter but yes, a 215/75-14 trailer tire will have a slightly larger circumference than a 205/75-14 tire. Specifically, the 205 will have a circumference of about 82.582 inches whereas the 2015 will have a…
view full answer...The main difference between a radial ply and bias ply tire is how the tire is constructed. The cords underneath the tire are run in different directions. On a bias tire, the cords run at a 32 degree angle from the direction of travel and on a radial…
view full answer...Related Searches
Filter Your Search
Contact and Help