Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
Updated 09/03/2021 | Published 08/24/2021 >
Question:
The instruction PDF says to install the electric motor on the opposite side of the square tube from the drive gear inside. The customer horse trailer, like mine, has a spare tire in the way. The customer mounted on the other sidefrom the tire which is the same side the drive gear inside the square tube is located. The cover screws then have to be installed from the back. I assume that the raise and lower switch is then labeled wrong? ...or do I reverse wires in the junction box? green to red, white to black ...or is the drive gear reinstalled on the opposite side in the square tube? ...or does any of this really matter?
asked by: Sregord
Expert Reply:
I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit
# BD1824200100 to the slave jack itself.
He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as well. You do not need to to reverse the wires in the junction box.
Continue Researching
- Shop: Demco Trailer Coupler - Cast - Adjustable Channel - eZ-Latch - Black - 2-5/16" Ball - 21K
- Shop: Dexter Unitized Oil Seal - Double Lip - I.D. 2.250" / O.D. 3.376" - 7K to 8K Axles - Qty 1
- Shop: Dexter Trailer Hub and Drum for 8,000-lb E-Z Lube Axles - 12-1/4" Diameter - 8 on 6-1/2
- Shop: Dexter Trailer Hub and Drum Assembly for 7,200-lb Axles Manufactured After 1999 - 8 on 6-1/2
- Shop: Single Rocker Switch - On/Off - Black
- Shop: Oil Bath Seal - Double Lip - ID 2.250" / OD 3.376" - ALKO/Hayes 8K Axles #42 Spindle
- Shop: Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles - 94" Long - 7,000 lbs
- Search Results: trailer light switch
- Search Results: electric trailer jack
- Search Results: 8~393~5
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Q&A: How to Remove Pin in Handle Shaft to Replace Gears on an Older Bulldog Model 12 Square Jack
- Search Results: trailer jack
- Video: Comprehensive Review: Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
- Q&A: Trying to Get Inner Drop Leg of Bulldog Jack to Move After Getting Stuck All the Way Down
- Q&A: What is the Purpose of the Spring Inside of a Bulldog 12K Square Jack
- Q&A: Replacement Parts for Bulldog Square Jack
- Q&A: Troubleshooting A Roll Pin That Won't Slip Into Place In A Bulldog 10K Square Jack
- Search Results: weigh safe trailer hitch ball mount
- Shop: Suspension Enhancement
- Q&A: Troubleshooting Bulldog Electric Landing Gear that Turns But Does Not Raise or Lower Jack
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Article: How to Measure for Trailer Hitch Drop
- Video: Hands-On with the Hub Saver Hub and Wheel Protector