Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
It is not uncommon for certain factory brake controllers to have issues with electric over hydraulic brakes. This would be the first we have heard of this issue with a 2023 Ford F-350, but it is possible that the brake controller in your ford is…
view full answer...Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…
view full answer...A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…
view full answer...There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…
view full answer...We can get you a good replacement, though there is actually no longer a TDE brand. But that actuator is simply a bolt-on, 7,500 lb actuator that couples to a 2" hitch ball, and per the owner's manual does not have a lockout (so it is for…
view full answer...The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.
view full answer...To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…
view full answer...According to your owners manual, you can absolutely flat tow your specific model. It is not recommended to tow this vehicle over 65 mph. You will also need to start the engine and allow it to run for five minutes at the beginning of each day and…
view full answer...We do not have a seal that matches the inner and outer diameter you have provided. That being said, I believe the markings on the seal actually indicate that your ID is 1.25" and our OD is 1.979". Your measurements are incredibly close to…
view full answer...The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you some…
view full answer...Yes, you have a couple of ways to test the Dexter DX Series Electric Over Hydraulic Brake Actuator #K71-651. The first test to try is to connect the white wire to the negative post of the battery. Then connect the black wire to the positive post on…
view full answer...From what I could find out about your current circuit board, the Atwood Replacement Control Panel #AT91367 will be a direct replacement.
view full answer...Filter Your Search
Contact and Help