Lippert Camper Jacks - LC52ED

If your RV is already prepped for the Ground Control 3.0 system, this kit has everything you will need to automatically level and stabilize it, without unneeded, duplicate components.

Features:

• Electronic leveling system lets you quickly and easily level and stabilize your 5th-wheel RV
• Auto-level feature automatically levels your trailer perfectly with the touch of a button
  • Manual mode lets you move each jack individually or in pairs
• Touchpad control has easy-to-read buttons and LCD screen
  • Mounts inside a front exterior storage compartment with included hardware
• 6 Motorized jacks raise, lower, and support your RV
  • Drop legs on front landing gear allow for greater adjustability
  • Precise leveling using Hall effect technology - measures motor revolutions per minute instead of amps
• Sturdy steel construction with corrosion-resistant black powder coat finish
• Manual override access on the jacks allows operation in case of a power failure
• Large, round footplates keep jacks from sinking into the ground
• Bolt-on jack installation with included hardware - no welding required
  • Rear jacks install on 8", 10", or 12" frames with included mounting brackets - drilling is required
  • Front landing gear uses existing mounting points on your RV
• 12-Volt system wires to your trailer's power source
  • Includes control module, sensor, wiring harnesses, and mounting hardware

Specs:

• Application: Prepped 5th-wheel trailers with a GVWR up to 15,500 lbs
• Quantity: 6 jacks
• Total travel:
  • Rear jacks: 12-1/2"
  • Front jacks: 36"
• 1-Year limited warranty

Note: Determine where these jacks will be mounted on your trailer. Use this system if there will be 20' or more between the center of the landing gear footpad and the center of the rear jack footpad. If your setup requires less than 20' between the jacks, use the 4-point Ground Control system (LC358590) instead.

Leveling your fifth-wheel RV has never been easier thanks to the Ground Control 3.0 electric leveling system. The motorized leveling legs eliminate the need for labor-intensive, manual scissor jacks. And the auto-level feature takes out the guesswork by automatically and precisely leveling your RV. All you have to do is step back and watch as Ground Control 3.0 levels your rig right before your eyes.

Automatic Leveling for Your 5th-Wheel RV

The auto-level feature provides the easiest, most efficient way to level your rig. With automatic leveling, you don't need to go through the trial and error of referencing levels and manipulating jacks one at a time. Just set the level position (zero-point) once, and the Ground Control 3.0 will bring your RV to that same preset point each time.

When first setting up the Ground Control 3.0 you will need to manually level your RV. With some leveling systems, manipulating the jacks individually can result in damage to your trailer's frame. Ground Control has built-in twist prevention so that you won't have to worry about twisting and damaging your frame.

In addition to automatically leveling your RV, the Ground Control 3.0 can also correctly position your trailer for hookup with the hitch recognition feature. This time-saving function stores your RV's position when you unhook from your tow vehicle so that it can automatically return the RV to that position when you're ready to hitch back up again.

Motorized Jacks with Hall Effect Technology

The 6 motorized jacks included with the Ground Control system employ Hall effect technology to precisely and quickly raise and lower your RV. These jacks use sensors to measure the number of motor revolutions per minute instead of amp draw. This allows for more precise control over the motor than you'd have with conventional motorized jacks, which results in more accurate leveling of your trailer.

Convenient Operation

Ground Control 3.0 offers 2 convenient ways to level your rig. Setting up camp is at your fingertips.

Touchpad with Lighted LCD Screen

The included, easy-to-use touchpad makes leveling your RV as simple as pressing a few buttons. The lighted LCD screen provides helpful prompts and alerts you to the status of the system. There are also indicator lights that let you know what functions are being performed.

Installation

Upgrading your rig with the Ground Control 3.0 system is simple. The 2 landing gear jacks mount to existing points on your RV and secure with included hardware. The 4 rear jacks come with mounting brackets that bolt onto 8", 10", or 12" I-beam frames with included hardware. Mounting the rear jacks does require drilling. A sensor is also included for the rear jacks. This will be mounted on a crossmember near the rear jacks.

The control module for the system mounts in a compartment under the coach with included hardware. This module has a wiring harness that connects directly to your 12-volt battery. Wiring harnesses are also included that connect the jack motors, rear sensor, and the touchpad to the control module.

2021106810 Lippert Ground Control 3.0 for Prepped RV Electric Leveling System - Fifth-Wheel Kit - 4 Jack Set

Installation Details