Specific Measurements of Lead Jack Leg from Lippert Landing Gear Set # LC333964

Updated 05/01/2020 | Published 04/28/2018

Question:

What is the length from the center of the drive pin to the bottom of the first stop at the top of the jack? Also my lead jack is 30 3/4inch long with the 2 1/2 inch shaft. If this extra length is at the bottom of the jack shaft, the Lippert 29 1/2inch by 2 1/2inch LC333964 jack will probably work.?????? From the top of my jack to the center line of the drive pin is about 1 3/4 inch , From the drive pin center line , to the bottom of the first bracket stop is 7, There is 15 1/2inch between stops. From the top of the lower stop to the base of the jack is about 6 1/2. What is the length from the top of the lower stop on the Lippert LC333964 to the bottom of the jack leg?

asked by: Jess H

Helpful Expert Reply:

On the lead leg for Lippert Landing Gear # LC333964 the distance from the center of the drive pin to the bottom of the first stop was 7 inches.

From the top of the jack to the center of the pin was 1 inch.

And from the top of the lower stop to the base of the outer tube was 6 inches.

expert reply by: Michael H

Brad M.

4/29/2020

do you have a measurement from the top of the lead jack tp the top of the motor assembly?A complete diagram would be helpful. My access opening is 23. My existing length of the tube is 27.5 Atwood landing gearThank you!

Chris R.

5/1/2020

The outer tube on the Lippert Electric Landing Gear # LC333964 legs has an overall height of 29-1/2". From the top of the lead leg to the top of the motor assembly there is a distance of just about 3-1/4".