Nissan Frontier Truck Tailgate Lock

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers part #PAL9772 or part #PAL9555 will work on the Leer 100XQ Truck Caps because it uses a cable latching mechanism and the handle is not riveted on.

I checked with Pop & Lock for you and there is a system that they have confirmed will work with 2011 and newer Leer 100XL, Leer 100XQ, and Leer 700: - Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers…

The Leer 100XR isn't specifically listed by Pop and Lock but more than likely the #PAL9772 will fit. It requires a frameless, bonded glass door with a 1-1/8" center hole for a rotary latch. This particular kit would upgrade your…

As long as the rotary latch on your Leer topper has a 1-1/8" center opening then the Pop & Lock Power Lock Conversion Kit part #PAL9772 will work well for you. This unit will turn the existing manual handle on your topper into a…

The only Timbren kit that fits your 2024 Ford F-350 Super Duty is the Timbren Suspension Enhancement System #TFR350SDJ rated for 8,600 lbs. Please note these are only designed to help support your OEM suspension, and it won't increase your load…

The Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 will work on the A.R.E. MX series truck cap you referenced on your 2017 Ford F-250 Crew Cab Short Bed. This will give you a clean look along with the keyless…

Hey Shawn, yes the Air Lift Single Needle Gauge Panel part #AL26161 does have a light built into it. The spade connectors on the back of the gauge you'd run to the running light circuit which will light up when headlights are on.

Pop and Lock does have the manual locking tailgate handle, #PAL5500, that will work with your 2015 Toyota Tacoma with backup camera. You can turn it into a power locking handle by adding conversion kit #PAL8525.

I do have an option for you to get the locks working again but we don't carry Load Lock so I don't have any advice or replacement parts for this. That said, you should be able to pretty easily replace this with the Pop & Lock Power Lock…

The Bauer Products T-Handle Lock for Truck Caps #BA57VR comes with a J-327 key. So by ordering 3 of these they are all keyed alike. This particular handle is for locks rotating counterclockwise. We also have the Clockwise T-Handle #BA84VR if your…

So long as you have the Leer 100XC truck cap, the correct Pop & Lock is the following: - Pop & Lock Power Lock Conversion Kit #PAL9772 I verified this with the manufacturer for you.

According to Pop & Lock, the #PAL9772 should work on a Leer 700 truck topper with the existing handle. If for some reason the handle isn't working, you can swap out to a new handle that will work with your Pop & Lock system using the…