Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
On a single axle trailer you will want to have a hanger spacing of around 22-3/4 inches when using the 23-1/8 inch long Double-Eye Spring #e59SR. This will allow that rear shackle to correctly lean away from the axle for proper suspension travel.
view full answer...On single axle trailers typically you put the hanger spacing right at 1/4 of an inch shorter than the leaf spring length from eye to eye center. So if you were using the leaf spring part #e54SR that you referenced which measures 25-1/8 inches long…
view full answer...The trick here is to get as close as possible. If you are talking about less than 2 inches or so, there is nothing to worry about. Having the trailer tongue a bit too high is preferable to it being too low. You may be a good candidate for an…
view full answer...The Dometic 310 Part-Timer RV Toilet, #DOM37FR that you currently have, in tan, is a standard-height RV toilet with a ceramic bowl and slow-close lid. It is 20" tall with a seat length of 15-1/4" and seat cutout dimensions of…
view full answer...You'll just need to run to your local hardware store and grab a supply line to connect your Dometic 310 Part-Timer RV Toilet #DOM37FR to your water inlet. I had to do the same in the attached video below when the new toilet I was installing…
view full answer...The Furrion Single Zone Controller part #FACC12SA-BL does have a dip switch setup underneath the cover of it.
view full answer...The Repair Kit Fulton Wedge-Latch Cast Head Coupler, #F670801, is designed to fit the coupler #BD44125W0317 which does take a 2-5/16 inch ball.
view full answer...It cannot; here is what B&W states regarding using the Companion in the slide position (which they call the "maneuvering" position): "The maneuvering position is only intended for parking maneuvers and not for…
view full answer...In order for the Yakima SweetRoll Kayak Carrier w/ Tie-Downs - Saddle Style - Rear Loading Item #Y04074 to fit, the crossbars you are securing them to must be no wider than 3-1/2" and no taller than 1-11/16". The Thule TracRac…
view full answer...The 30205 bearing that you referenced has an inner diameter of just under 1 inch (0.985 to be exact). We do not have this particular bearing or a hub that uses this size bearing available. The #L44643 bearing that you also mentioned has an inner…
view full answer...The bearing that you have on the trailer hub measures just under 1 inch (0.985) and we are not going to have a hub that accepts a bearing with an inner diameter of that size. This is common for the trailer kits like the Haul Master branded…
view full answer...You are correct that the spring seats included in an over/under conversion kit like the Dexter Trailer Springs Over-Under Kit #K71-384-00 should be tack welded on in most cases. I checked with one of my engineering contacts over at Dexter and he…
view full answer...Filter Your Search