Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…
view full answer...There is a wiring kit for a brake controller Preston but it's not going to be a plug and play one. The 2025 Toyota Tacoma does not have a plug in brake controller port. Toyota stopped putting them in after the 2023 model. For your Tacoma, I…
view full answer...Hey Candido, thanks for the picture of your shackles. Based on that you have a 2-1/4 inch long shackle length which is very common so for an upgrade kit that includes much thicker shackles, wet bolts, and bronze bushings we have the part #MR46ZR.…
view full answer...Hi Lisa; the Rear View Safety Backup Camera #RVS-611-IR is the same as your RVS-MV3-IR. The RVS-MV3-IR replaced the RVS-611-IR and we retained that part number on our site. It still has a 5-pin connector, see the attached photo.
view full answer...Dan, they won’t. The Dexter 7K ABS brakes #DX69WR / #DX79WR are specifically designed for Dexter Tow Assist axles - the flange offset and ABS tone ring position are unique to Dexter’s design. On Lippert 7K axles, the sensor alignment won’t match, so…
view full answer...Hello Danny, thanks for reaching out. Yes, the Solera Awning Cradle Support #LC289373 can be used on an awning with a metal weather shield. It will work with virtually any awning that retracts into a cylindrical shape.
view full answer...Hey there Brad, We do have a replacement for the 125255UC grease seal; the correct seal is the following: - Double Lip Grease Seal #34823
view full answer...If you have 3,500 lb axles the best choice would be 3,500 lb springs so that you could take advantage of the full axle capacity (assuming the trailer is rated similarly). The #e54SR is a great choice for you as it is a 3,500 lb axle leaf spring.
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...Hey Don, for your 2024 Ram ProMaster we have the custom fit 7-way kit part #22112 which comes with everything needed to install a fully functional 7-way in your vehicle.
view full answer...I have a solution for you, but we do not have a double lip grease seal with the exact measurements you specified. However I was able to find out that the GS-1250 DL that you mentioned has the following measurements: Inside Diameter: 1.249"…
view full answer...Hey Susan, sorry to hear about your microwave. Due to it's age I wasn't able to find it's dimensions to pick out a replacement that would closely match it but I was able to determine it was a 1.0 cubic foot microwave like the High Pointe…
view full answer...