Search: 2" hitch extension   >   !Electrical Tools   >  

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

On single axle trailers typically you put the hanger spacing right at 1/4 of an inch shorter than the leaf spring length from eye to eye center. So if you were using the leaf spring part #e54SR that you referenced which measures 25-1/8 inches long…

The trick here is to get as close as possible. If you are talking about less than 2 inches or so, there is nothing to worry about. Having the trailer tongue a bit too high is preferable to it being too low. You may be a good candidate for an…

You'll just need to run to your local hardware store and grab a supply line to connect your Dometic 310 Part-Timer RV Toilet #DOM37FR to your water inlet. I had to do the same in the attached video below when the new toilet I was installing…

The Dometic 310 Part-Timer RV Toilet, #DOM37FR that you currently have, in tan, is a standard-height RV toilet with a ceramic bowl and slow-close lid. It is 20" tall with a seat length of 15-1/4" and seat cutout dimensions of…

The Furrion Single Zone Controller part #FACC12SA-BL does have a dip switch setup underneath the cover of it.

The Repair Kit Fulton Wedge-Latch Cast Head Coupler, #F670801, is designed to fit the coupler #BD44125W0317 which does take a 2-5/16 inch ball.

It cannot; here is what B&W states regarding using the Companion in the slide position (which they call the "maneuvering" position): "The maneuvering position is only intended for parking maneuvers and not for…

In order for the Yakima SweetRoll Kayak Carrier w/ Tie-Downs - Saddle Style - Rear Loading Item #Y04074 to fit, the crossbars you are securing them to must be no wider than 3-1/2" and no taller than 1-11/16". The Thule TracRac…

The bearing that you have on the trailer hub measures just under 1 inch (0.985) and we are not going to have a hub that accepts a bearing with an inner diameter of that size. This is common for the trailer kits like the Haul Master branded…

You are correct that the spring seats included in an over/under conversion kit like the Dexter Trailer Springs Over-Under Kit #K71-384-00 should be tack welded on in most cases. I checked with one of my engineering contacts over at Dexter and he…

You cannot use a weight distribution system with a pintle hitch. You would need to remove the pintle hitch you have now in order to use a weight distribution system. Once you do this, I recommend using the Equal-i-zer Weight Distribution System…