See what our Experts say about this etrailer Trailer Jack

• Does Your etrailer Jack Automatically Stop when it is Extended so it Doesn't Over Extend?
  Hello Jeremy, Yes, our etrailer jack # e55ZV will automatically stop and not over raise. If you check out the video that I attached you will see that Steven still has his finger pushing down the button after the jack stops. What kind of application are you putting this on?
  view full answer...
• Does Your etrailer Jack Come With a Warranty? How Long is the Warranty?
  Hello Jesus, Yes, our etrailer jack # e55ZV has a 2 year warranty. What kind of trailer will you be using this on?
  view full answer...
• Electric A-Frame Jack for 2019 Jayco SLX 212QB
  Hi Mark; the only jack like that is the Lippert Power Stance Electric Trailer Jack # LC89VR but it exceeds the amount you're looking to spend. If you're fine with one that only runs off of the 7-way then I recommend the etrailer Electric Trailer Jack w/ 7-Way # e74GV. Most of the time people get a jack that wires directly to the trailer batteries like # e55ZV but you can really do whatever works best for you. If you're connected to the batteries you don't have to position your truck to...
  view full answer...
• Does etrailer 5K Electric A-Frame Jack Need an In-Line Fuse?
  Hey Jeffrey, thanks for reaching out! The etrailer Electric Trailer Jack # e55ZV does not require an additional fuse/relay as it has an auto-reset on built-in, and the outer diameter of the jack tube is 2-1/2". Are you looking to replace an older electric jack, or looking to upgrade from manual to electric?
  view full answer...
• Electric Trailer Jack Recommendation for 2022 Shamrock Flagstaff 19
  Hey Gary, if you wanted a powered a-frame jack that works great and also doesn't break the bank we have the etrailer jack part # e55ZV. Now if you were looking for something really nice that raises and lowers in a matter of seconds the Phoenix jack part # UF38-944055 would be what you would need.
  view full answer...
• What Is The Distance From Tube To Outer Head Of etrailer Electric Trailer Jack # e55ZV ?
  Hey there Greg! The etrailer Electric Trailer Jack - Drop Leg - A-Frame - 18" Lift - 5,000 lbs # e55ZV has a measurement of 4-3/8" from the outer tube to the furthest point of the head. This tells me you should be good to go, but just barely! What happened to the old jack? Just finally gave up after so many years?
  view full answer...
• Replacement For Lippert Power Tongue jack On A Jayco Jay Flight 32BHDS
  Hi Scott, thanks for reaching out. A great replacement for the 3,500-lb Lippert jack on your Jayco 32BHDS is the etrailer Electric Trailer Jack – A-Frame – 18" Lift – 3,500 lbs # e23ZV. It’s a bolt-on swap with the same capacity, upgraded weather-resistant switches, a built-in LED light, and a manual crank backup in case you ever lose power. It also includes a vinyl cover to help keep it protected when not in use. Are you mainly looking to replace it because the old jack is getting slow...
  view full answer...
• Will etrailer Electric Trailer Jack e55ZV Work On 1979 Airstream Excella 500
  Hello Jorge, thanks for reaching out. The etrailer Electric Trailer Jack # e55ZV should work great on your 1979 Airstream Excella 500. It uses a standard bolt pattern (3" apart on center) so as long as you can confirm this matches the current jack, it'll work great for you. I went out to our warehouse and grabbed one of the jacks to get the measurement you asked for. I measured approximately 5-1/2" from the center of the post to the farthest point on the motor case. I edited a picture...
  view full answer...
• Do You Carry a Replacement Switch for You etrailer Jacks, What if Mine Goes Out?
  Hello Brian, Thank you for reaching out. While we don't offer a replacement switch for our etrailer Electric Trailer Jack - A-Frame - 18" Lift - 5,000 lbs # e55ZV, there's some good news: this jack comes with a 2 year warranty. That means if the switch were to go out in those 2years, it would be covered, because we truly stand behind the quality of our product. What kind of trailer are you putting this on?
  view full answer...
• What is the Measurement From the Mounting Plate to the Top of the Jack on the etrailer Jack 5k?
  Hello John, I was not able to find that information anywhere, luckily we have one on a trailer right outside. From the top of the mounting plate to the top of the jack is 20 1/4". What kind of trailer were you thinking about putting this on?
  view full answer...
• Is There a Electric Trailer Jack that is Actually Fast
  Hey Raymond, since the 5k rated etrailer jack part # e55ZV is rated higher than the 3.5k option you also mentioned it will work a little bit quicker since it won't be working quite as hard. With that said it's not a fast jack by any means. It would still require a decent amount of time as that's the nature of these types of jacks. Now if you really want something that moves quickly we have the Phoenix jack part # UF38-944040. This will extend 6 inches with a heavy load on it in 9.5 seconds...
  view full answer...
• Do The etrailer Electric Trailer Jacks Have A Manual Backup Option?
  Hello. The etrailer Electric Trailer Jacks # e55ZV and # e23ZV do have a manual backup option. You just remove the rubber cap on top of the housing and you can use the included manual crank to raise/lower the jack. Take a look at the picture below and let me know if you have any other questions.
  view full answer...
• Can The etrailer Electric Trailer Jack e55ZV Be Rotated To Help With Tailgate Clearance?
  Hello Bruce, yes it can. The etrailer Electric Trailer Jack # e55ZV can be rotated to the size and the bolts will still line up. We have this jack on one of our trailers here at the shop and I have checked and verified it can be rotated.
  view full answer...
• Does etrailer Powered A-Frame Jack # e55ZV Have Light for Night Cranking/Jacking
  Hey Andrew, great question but yes the etrailer Electric Trailer Jack # e55ZV that you referenced does have a really bright LED light that will make it easy to see as you are night jacking/cranking. I also think it's important to have plenty of light when you are really cranking it for safety sake. I attached a picture of the light to give you an idea how well you'd be able to see if you were doing some night cranking/jacking at your friend's campsite for example.
  view full answer...
• Replacement A-Frame Jack for a 7,000 lbs Travel Trailer
  Hey Hal. To replace your 2014 Creekside 23RKS trailer's jack you'll want to go off of the tongue weight. Since your trailer has the traditional a-frame mounting bolt pattern, I recommend the etrailer Electric Trailer Jack item # e23ZV. The etrailer item # e23ZV has a 3,500 lbs capacity and has an 18" lift. The jack includes LED lights, a cover to keep it protected, and also comes with a limited lifetime warranty. In the event your trailer battery is dead there is an emergency manual crank...
  view full answer...
• How Well Does etrailer Electric Trailer Jack Hold Up To The Elements
  Hey Layne; that is a great question! The etrailer Electric Trailer Jack # e23ZV is designed to withstand all kinds of weather. It actually has weatherproof buttons covered with a rubber-like boot to keep water out. On top of that, yes, there is a cover which is included with the jack. Between the built-in protection and the canvas cover the jack will hold up really well over time. It is also backed by a limited lifetime warranty. All of this applies to the 5,000 lb version of the jack...
  view full answer...
• What is the Mounting Bolt Pattern of the etrailer Electric Trailer Jack?
  Hey Jimmy, welcome back! The etrailer Electric Trailer Jack item # e55ZV has the standard A-frame jack mounting bolt pattern of 3" on center. The mounting bracket has slotted holes so there's some wiggle room too. The outer tube diameter is 2-1/4". The etrailer item # e55ZV has a 5,000 lbs capacity and provides an 18" lift. The jack includes LED lights, a cover to keep it protected, and also comes with a limited lifetime warranty. In the event your trailer battery is dead there is an...
  view full answer...
• Does The etrailer Electric Trailer Jack e23ZV Have A Built In Light?
  Hey Bobby, thanks for reaching out. The etrailer Electric Trailer Jacks # e23ZV and # e55ZV do indeed have a worklight built in. Take a look at the picture below. There is not a separate wire for the light. As long as you connect the red wire to 12v power and the black wire to ground the light will operate normally. The on/off switch for the light is on the top/front of the jack housing right by the switch for operating the jack.
  view full answer...
• Does the 5K etrailer Electric A-Frame Trailer Jack Come with a Warranty
  Hey Kayla, thanks for reaching out! We back the etrailer Electric Trailer Jack # e55ZV with a limited lifetime warranty so you can be confident we'll have your back a long ways down the road from now. If any problems come up just let us know and we'll be happy to help get you back up and running!
  view full answer...
• Does Your etrailer Jack have Auto Stop so it Doesn't Over Extend so the Gears Don't get Damaged?
  Hello Wesley, Yes, our etrailer jack # e55ZV does automatically stop and will not over extend. If you check out the video that I attached you will see that jack stop at the top while Steven still has his finger pushing down on the button. Not only does it have the auto stop, but it is also the only jack that we carry that has a limited lifetime warranty! Any fun trips planned in your Airstream this year?
  view full answer...
• Is The etrailer Electric Trailer Jack e55ZV Weatherproof?
  Hello Nick, thanks for reaching out. The etrailer Electric Trailer Jack # e55ZV is designed to be weatherproof. The plastic housing will keep water out. All of the buttons are covered in a flexible rubber that keeps the elements out and protects the housing. Additionally, this jack comes with a vinyl cover that goes over the top. Keeping the cover on will not only protect it from water, but from UV rays as well. UV rays can be more damaging to the parts than water, so keeping the cover...
  view full answer...
• Length of Wire on etrailer Electric Trailer Jack
  Hi Richard; the wire on the etrailer Electric Trailer Jack # e55ZV is approximately 6' long. It uses 12 gauge wiring so if you need more wire you can add # 12-1-1 along with some butt connectors # DW05745-1. If you have any other questions feel free to reply below.
  view full answer...
• Would Rear Door of 2016 Jeep Grand Cherokee Interfere with etrailer Trailer Jack # e55ZV
  Hey Cindy, that would depend on a few things but a good indicator would be if the rear door of your 2016 Jeep Grand Cherokee is hitting the manual jack your 2024 TAB 400 has currently. If so, then yeah it would definitely hit the powered jack part # e55ZV. If it's pretty close currently then it might not hit it but one solution would be a ball mount that is longer to get the distance further out and would prevent the interference. I would need to know the amount of drop your current ball...
  view full answer...
• How Does The etrailer Electric Trailer Jack e55ZV Hold Up In Cold Weather?
  Hello, and thanks for getting in touch. The etrailer Electric Trailer Jacks # e55ZV and # e23ZV will hold up just fine in cold weather. The housing is designed to be water/weather resistant. It even has a manual backup option if you were to lose power for some reason. The jack actually includes a vinyl cover that goes over the motor and housing. Keeping this cover on the jack as often as possible will undoubtedly increase the lifespan. While I don't necessarily recommend it, I have heard...
  view full answer...

Do you have a question about this Trailer Jack?