Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Sidewind - 14-7/8" Travel - 2K

Video Transcript for etrailer Trailer Jack - Side Frame Mount Jack - TJP-2002S-B Review

Today we're going to be taking a look at Round Pipe Mount Swivel Jack. This jack does include the foot plate. This utility jack is going to let you raise and lower your trailer. It's going to have a lift capacity of 2,000 pounds and a support capacity of 3,000 pounds. This is going to feature the tubular swivel design, so that's going to let you move the jack up parallel to the trailer frame for storage or during travel and you can bring it back down for use. It does come with the pull pin.

That's going to hold the jack in place in the stowed position or the usable position. It's going to be connected to the jack with a chain lanyard. That's going to connect the pin to the jack so you don't have to worry about losing it or misplacing it and it's going to come with the weld on pipe mount. This is the piece that gets welded to the trailer frame and then this portion right here fits right over. You see how there's four holes in it so you can move it to any position when you're ready to store it. It's a really nice design.

Very easy to use. That weld on piece is going to have an outer diameter of 2 inches, so outside edge to outside edge. This jack also features a side wind handle. It's going to allow for easy cranking when it comes to raising and lowering the jack. You can see right here, it's got a nice fluid motion.

I don't feel any kinking or binding. Nice smooth operation. The actual handle has a textured surface, a gripped area. That way you can get an easy hold on the handle when you're raising or lowering the jack. It's a really nice design. This unit's going to give us a handle radius measuring from the center of where the handle mounts to the outer edge of the hand drip.

The handle radius for this particular one is going to be right around 6.5 inches. The jack is going to made from a steel construction. The outer tube, that's going to have a really nice black, powder coat finish on it. The inner tube and the foot plate are going to have a corrosion resistant zinc finish on it. The foot plate is welded to the base of the inner tube. The foot plate is going to give us an overall length measurement of 7.5 inches. The width measurement is about 3 3/4. That's going to do a really good job at spreading out the applied weight, especially on softer ground to prevent sinking. It's going to increase overall stability. Maintenance is very easy with the jack. It's got a built in grease zerk fitting. That way, all you have to do is attach your grease gun, pump your grease in. It's going to lubricate the internal components. When it comes to the bracket height, I'm going to measure from the bottom of the foot plate to the center of the weld on bracket. With the jack at its lowest setting, this is going to give us a retracted bracket height measurement of 15 1/4 of an inch. I did that same measurement with the jack fully extended. That increased to 30 1/8 inches. This is going to offer a travel or lift of about 14 and 7/8 of an inch. The outer tube is going to give us a diameter of 2 1/4 inches. The inner tube is going to give us a diameter of 2 inches. That's going to do it for today's look at the Round Pipe Mount Swivel Jack with the included foot plate. Again, this has a lift capacity of 2,000 pounds and a support capacity of 3,000 pounds.