Parts Needed To Mount A Tube-Style Swivel Jack To A Trailer Frame
Updated 04/18/2023 | Published 04/17/2023
Products Featured in This Question
Question:
Dear Sir or Maam, Is there a kit for affixing a swivel tube-style mount to an existing trailer jack?
asked by: Mike
Expert Reply:
To mount the Bulldog Round Jack without mount # 150010 to a trailer frame you would need to use weld on a female swivel pipe # TJP-OP916 to the jack. If you trailer doesn't have the male swivel pipe then you would need to weld part # DL22670 onto the frame as well.
If you don't know how to weld or would prefer not to pay for someone else to do it then you can also just get a similar jack with the swivel components already attached like part # TJP-2002S-B.
Product Page this Question was Asked From
Bulldog Round Jack without mount - Sidewind - 10" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jacks
- Sidewind Jack
- 1001 - 2000 lbs
- Manual Jack
- 10 Inch Lift
- Weld-On
- No Wheel or Foot
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Looking For A Demco DA86 Actuator For Drum Brakes Specifically
- Article: Performance Chips and Modules
- Q&A: Do I Need To Bleed The Brakes After Installing Demco DM28CV Brake Actuator On Trailer?
- Q&A: Surge Brake Actuator Replacement Recommendation for Atwood Model 84132
- Q&A: How To Tell The Difference From Right and Left Electric Brake Assemblies
- Q&A: Availability of Sidewind Pipe Mount Jack that Has Removable Foot
- Q&A: Recommended Replacement for 7.00-15LT Tires
- Q&A: Red and Amber 2-1/2 Inch Round LED Trailer Lights with Grommet and Plug
- Article: How to Change a Trailer Tire