Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Okay Bob, so I did a bit of digging around and apparently this is a known issue that Blue Ox is aware of. The 41" distance between the mounting points is too wide and non-standard which is why your tow bars are being stretched too far.…
view full answer...Hi Chris; your 2022 Ford Expedition will have a Normally Closed application, and it is possible when installing the Roadmaster Brake-Lite Relay Kit #RM-88400 that you'll need Hy-Power Diode #RM-790. I can't say for sure because…
view full answer...Absolutely. The Roadmaster InvisiBrake Supplemental Braking System #RM-8700 typically installs under the driver's seat for easy accessibility but it is not the only place it can be mounted. You can mount it anywhere in your towed vehicle that…
view full answer...I prefer the Blue Ox flat towing setups over the Roadmaster kits as I have found them to be just a little easier to use and they are very well made. I wouldn't worry to much about the bumper cuts and it doesn't affect the shudder…
view full answer...I have a solution for you, but there is not an exact size replacement available for your Atwood GCH6A-10E water heater, which looks like was 16" wide x 12-1/2" tall x 20" deep. With that said, the closest match is…
view full answer...I apologize for any confusion on what the proper torque specs are for 1/2 inch lug nuts on trailer wheels. I attached a picture of a chart to the right that details what the proper torque specs are for a trailer wheels lugs based on lug size, wheel…
view full answer...If it is a 1000 psi then it would be the Hydrastar for drum brakes. The newest one is #HBA-10 and it has different wire colors, see picture. So you know that black is 12 volt power in and white is the ground. Blue/white goes to the break away…
view full answer...The TDE 46245 you have is a Hub and Rotor for a 3500lb axle and uses inner bearing #L68149 and outer bearing #L44649 and uses the 5 on 4-1/2" bolt pattern For a replacement idler hub you can use the Trailer Idler Hub Assembly for 3,500-lb…
view full answer...We do have a large selection of replacement lenses available, however Reflect-O-Lite is no longer in business and replacement parts are not available. It is very unlikely that a replacement lens from a different brand assembly will fit, so your…
view full answer...We can get your 2022 Ford Expedition set up to be flat towed behind your Prevost motorhome with air brakes, and there are a number of parts you'll need, which I'll go ahead and list out for you below. The only thing to note is that…
view full answer...I am happy to help you setup your 2020 Lincoln Nautilus for towing. You are going to need a receiver hitch, wiring harnesses with a 7-Way connector, brake controller, and a ball mount. I recommend the Curt Trailer Hitch Receiver Item #C78KR. This…
view full answer...The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be…
view full answer...Filter Your Search
Contact and Help