Hey Peter! Hopefully nobody was hurt, including your camper. Since you have a trigger latch I would add a lock like the InfiniteRule Trailer Coupler Lock #IR58FR. This will keep it secure while you're hooked up to the ball mount on your vehicle…
Our most economical camper tie downs are the Brophy Camper Hold Downs, #HSSF, and the Stake Pocket Tie Downs, #TDSF. These are universal tie downs designed to fit a number of trucks. I spoke with Brophy and they have not tested these tie downs on a…
The correct replacement circuit and control board for your Lippert Electronic leveling system is the Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System #LC421484. This will be a plug and play solution, so…
The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…
I have linked the instructions for the HappiJac Truck-Mounted Camper Tie-Downs #LC184089 that fit your 2013 Toyota Tundra below. Be sure to get a set of HappiJac Original Turnbuckles #LC182898 as they are stainless steel and will last through the…
Hey Scott, so the HappiJac Truck-Mounted Camper Tie-Downs item #LC182910-182971 actually does not have any weight capacity because they are designed to handle the weight of any truck bed camper. This also applies to any camper tie-down, which is why…
The best and most secure camper tie down system that fits your 2016 Toyota Tundra 6.5 foot bed double cab is by far the Happijac system part #LC184089. This kit attaches to the truck frame instead of to the bed which provides a much stronger and more…
Unfortunately we do not have a video of the HappiJac Truck-Mounted Camper Tie-Downs #LC184089 being installed. The Rear anchors are installed in the end of the bumper. There is no precise mounting location since a variety of bumpers may be installed.…
The best solution is going to be to go with a double eye leaf spring setup instead of what you have now. For that the leaf spring part #e57SR is for a 4,000 lb axle and has a 25-1/4 inch length from eye to eye. Then for a hanger kit you'd want…
The only tank equipped RV water heat option we currently offer is the Dometic RV Water Heater part #DMC74FR which is a 120 volt unit with 6 gallon tank and gas/electric operation. In regards to installation, this must be performed by a qualified…
Yes, you can use a 2-1/2" to 2" trailer hitch sleeve adapter with a weight distribution system. I recommend the Trailer Hitch Receiver Reducer Sleeve part #e33YR which has a 3" to 2-1/2" and a 2-1/2" to 2" for this. The…
According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…
Filters
