Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
It is not uncommon for certain factory brake controllers to have issues with electric over hydraulic brakes. This would be the first we have heard of this issue with a 2023 Ford F-350, but it is possible that the brake controller in your ford is…
view full answer...It sounds like you have a wishbone wiring harness install on your trailer. A regular 4-way wiring harness has 4 wires from the back of the connector, 1 for left turn/brake typically (yellow), 1 for the right turn/brake typically (green), 1 for the…
view full answer...The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.
view full answer...To replace your JVR9000 I recommend the Jensen RV Stereo - Double DIN - AUX/USB, Bluetooth #JWM40. It has slightly different dimensions that can be easily fixed using a dash plate. This won't have a monitor to watch your video feeds from so…
view full answer...Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…
view full answer...The first thing you'll want to do is use a circuit tester like #PTW2993 on the turn signal pins in the 7-way trailer connector with each turn signal activated with the ignition on. The right turn is the pin in the 3:00 position, the left turn is…
view full answer...From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…
view full answer...We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…
view full answer...I have added a photo detailing the wiring connections for the Pollack Heavy-Duty, 7-Pole, Round Pin conncetor, #PK11700, see link. This is a SAE J560 compliant connector. The wiring diagram for the vehicle side connector, #PK11720, is pictured also.…
view full answer...A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...The only way will be to replace the entire assembly as the rear back plate is not available by itself. For that you'd need the part #RVSTLB61. The great news is that the price for this is very reasonable and you get an all new assembly.
view full answer...Filter Your Search
Contact and Help