Mount your round, 3" diameter axle to your trailer's leaf springs with this U-bolt kit. U-bolts, plates, nuts, and washers included. Zinc plating resists rust and corrosion - great for boat trailers.
Features:
Specs:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today, we'll be having a look at the CE Smith line of U-bolt mounting kits for mounting round trailer axles. Here's what our kit comes with. It's everything you need for replacing the U-bolts on a single axle on your trailer. We have 4 new U-bolts, you'll have 2 per side; 2 new plates, 1 per side; 8 new lock washers, you'll be using 4 for each side of the trailer; and 8 new nuts, again 4 for each side of the trailer.You can see how well our U-bolts grip around the contours of our axle. This'll keep the axle firmly attached to our leaf springs, so we don't have to worry about it slipping and sliding.Now because we have the zinc and the galvanized finish on our plate and our hardware, this will better protect them from corrosion from the elements, especially salt spray. It's not an issue if you decide to use them on a boat trailer such as this one.Now many of our customers have had to make a second phone call or send an email to us after they bought a new axle for their trailer because they found, once they tried to remove the old one or put the new one on, that they couldn't get their factory U-bolts off.
They had to cut them off, and now they're searching for a replacement. This kit will be a perfect solution for this problem here.Now many of our customers compared these to the Redline line of U-bolt kits. Now the main difference you're going to see between this one and those is that those do not have the galvanized or the zinc finish on the plates or the hardware, which will cause them to rust out faster.As you can see, we already have our new axle sitting on top of our leaf springs. Now this kit could work for an axle that sits on top or below your leaf springs. It works for both applications.
You don't need to worry if yours resides below, you can still use this kit for that.We'll start by taking our new U-bolts and dropping them over our axle on either side of our leaf spring. Now we'll take our new plate. We want to make sure that this flange right here faces down, this hole here in the center lines up with the alignment pin on our leaf spring, and we'll insert our U-bolts through the holes. Place on our lock washers, and we'll put that on our nuts.Now we can start to tighten our hardware, making sure we tighten them evenly as possible. Now we'll torque our hardware again, making sure we alternate to ensure that we're doing it as evenly as possible.And that completes our look at the CE Smith line of U-bolt kits for mounting round trailer axles..
Do you have a question about this Trailer Suspension Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.