Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Getting a trailer into tight storage spaces or angled driveways doesn’t have to be a hassle. The Dutton-Lainson Pull Pin, Easy Swivel Trailer Jack rotates out of the way fast and locks back down securely when you need it. The pull-pin lets the jack swing up smoothly, so you can move or park your trailer by hand without dragging or fighting resistance. It’s a handy setup when you’re working in compact areas or need to change direction quickly.
This jack gives you the right amount of muscle for steady hitching and leveling. With a 2,000 lb capacity and 10" of lift, it handles most small to mid-size trailers with ease. The 18" overall height and 11-1/2" bracket height keep it balanced and stable during cranking. Side-wind operation makes fine adjustments smooth and controlled, whether you’re setting up at a campsite or swapping your trailer into storage.
Rough terrain and weather exposure won’t wear this one down easily. The included weld-on bracket and 2-1/4" diameter snap ring make for a secure, long-term mount. Its matte black finish adds a layer of protection against the elements while keeping a clean look. Once welded on, the jack stays solid and dependable through repeated use and travel.
No wiring or motors to worry about here. The manual side-wind handle lets you raise and lower smoothly without overcomplicating things. It’s a straightforward design that just works, ready whenever you need to lift or position your trailer. And with Dutton-Lainson’s 3-year limited warranty behind it, you get confidence that it’s made to last through years of towing and storage.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everybody. Andy here with etrailer.com. Let's take a look at this Dutton-Lainson-Goldenrod Easy Swivel Sidewind Trailer Jack with Foot. This Goldenrod Swivel Utility Jack is going to let you raise and lower the tongue of your trailer so you can connect and disconnect your trailer coupler to and from your hitch ball. And this jack features a lift capacity of 2,000 pounds. This is made here in the USA, and the outer and inner tubes are constructed of heavy gauge steel.
The heavy duty ACME screw, and miter gears are totally enclosed in the outer tube to help protect it from sand and dirt. And the jack itself is protected by a nice matte powder coated black finish. Now this does have a swivel design that's going to let you swing the jack up for storage along the trailer frame, and then you can bring it back down for use. And as you can see here, this does include a convenient, easy to operate half inch spring loaded pole pin that's going to secure and release this jack. This is a weld-on bracket that is included here.
And you can see when I pull the pin to release the bracket, how the bracket itself swivels independently from the jack. So when this bracket is welded to your trailer jack or to your trailer rather, you're just going to pull the pin, and then you can rotate that jack up in a stowed position, and then easily bring it down, bring it back down for use. Now you'll notice that our bracket has four holes in it, and that's going to allow our pin to engage in whatever hole is going to work best for your particular application whether you want the jack facing towards the front or if you want it facing towards the back pointing towards the rear of the trailer. So again, very easy, very convenient to use. The pin is spring loaded.
Looking at the measurement of the bracket itself, we are four and a half inches square and this sidewind handle has an extra heavy screw drive, and it's ergonomic. It has an ergonomic molded handle grip with a textured surface. So this is gonna be very easy to hold onto, especially if it's damp weather. And let me flip this over here, just so you can see our foot plate. The foot plate is welded on, so it's not gonna go anywhere.
It's gonna be very durable and strong. Looking at the length, we're sitting right at seven inches long. The width four inches wide, so you've got a nice wide base there. And then let me make sure that I have this fully retracted, and just give you some other measurements here. I want to give you the bracket height, when this is fully retracted. So I think I can do this with my ruler here. Measuring from the base that this is sitting on all the way to the center of our bracket. As you can see, we're sitting right at 11 and a half inches when it's fully retracted. Now when you have this fully extended, you're gonna get a travel of 10 inches. So when this is fully extended, again from the base to the center of our bracket, this is gonna be sitting at 21 and a half inches on that fully extended height. And then the overall height of this jack, when it's fully retracted from the top to the bottom, we're sitting right at 18 inches tall when this is fully retracted overall. Well that's gonna wrap up our look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.
Customer Satisfaction Score:
95% were satisfied with this product
5% of customers were not satisfied
Ratings & Reviews
Brooke M.
11/11/2024
Very glad to hear this jack worked well for you! The Semper Fi caught my eye. My youngest brother just graduated from boot camp and is leaving for California today to start training before he heads to Florida for his more specialized training in the Marine Corps. Are you a Veteran or are you currently enlisted?
Brooke M.
11/12/2024
George D.
9/27/2025
My trailer jack is working just like the day I installed it. I am totally satisfied with it and recommend it highly!! AND I have recommended it to other boat owners I know!! Semper Fi to all the Marines and Happy 250th Birthday!!
Michael
3/31/2025
Great,hope this helped other guys with ranger trail trailers with the welded plate
Do you have a question about this Trailer Jack?
Condition: Surface Scratches
Notes: Item has minor cosmetic scratches.
Condition: Surface Scratches
Notes: There are scratches and paint chips on the jack.
Condition: Surface Scratches
Notes: There are scratches and paint chips on the jack.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Brooke M.
6/6/2025
Happy to hear that! USA! [Eagle screech of freedom!!]