Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Trailer Brake Magnet for 12" Hub/Drum
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today, we're going to take a look at the replacement trailer brake magnet for the Dexter, Alko, and Hayes 12" electric trailer brakes, this part includes everything shown here on the table, the magnet itself, the spring, and the clip to hold the magnet into place. This magnet kit will allow you to replace the worn-out magnet on your 12" trailer brakes, and because you're replacing just the magnet, not the whole assembly, it will save you time and money. This part is designed to work with the following brake assemblies, it'll work with the Dexter 12" x 2" on a 6000 pound axle, the Alko 12" x 2" on the 6000 and 700 pounds axles, the after-1988, and the Hayes 12" x 2" 600 and 7000 pound axles after 1988. If you notice, the magnet is an oval design, and they do that to increase the efficiency of the magnet, and to also extend the life of the magnet. Just to give you an idea of the size on this, the width of it you can see is about 3 1/8", and the height going to be right at about 2". You also notice, when the wires come out of the magnet, they have a section of a protective sleeve over that, and the reason they do that is because, when this is installed in your brake assembly, that initial part of the wire is what goes through the backing plate, so you don't want the wires rubbing up against the backing plate and causing problems, so they put this nice, protective sleeve on here to protect the wires from getting damaged. Also, if you notice, it has the two wires, two black wires coming out of it. It doesn't matter which wire from the magnet is attached to the power or the ground, you just want to make sure that one of the wires is properly grounded, and then the other wire will be attached to your electric brake output circuit from your trailer connector.
That should do it for the review of the replacement trailer brake magnet for the Dexter, Alko, and Hayes 12" electric trailer brakes.
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews

Jerry D.
12/30/2013
My order was correct and shipped promptly at a very reasonable shipping cost. Very satisfied with the service, I give it 5 stars

Richard H.
12/2/2022
They are doing exactly what they were designed to do !
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.









Bob W.
7/20/2015
Thanks for checking back with me as I had completely forgotten the trailer brake issues I had last year. The brakes are still functioning fine and we are now using that trailer to haul logs and equipment on a regular basis with absolutely no problems with the brakes. I wish I had reworked them earlier and would recommend the parts I used to anyone with a similar issue.