2006 Ford Explorer Vehicle Snow Plows

Hey Bruce! The support bar mounting issue you pointed out is why I am going to steer you away from using the Curt Front Hitch item #31302 to attach a snow plow on your 2006 Yukon. Those support bars on the SnowBear Snowplow item #K2AVAL8219…

Hello Walt. We do have snow plow kits that will fit your 2006 Chevy Trailblazer 4x4. The #SS78GV you were looking at will fit, you just will need to install the front hitch #31055.

For your 2006 Honda Ridgeline, the K2 Avalanche plow is only a fit for the front mounted receiver. The custom mount brackets #K286110 are not a direct fit for your Avalanche plow but the mount does come with a crossbar and I've attached the photo…

In order to use the Detail K2 Storm II Elite Snowplow part #K2STOR8422ELT on a 2002 Ford F-150 2WD you'll need the Custom Mounting Brackets for Detail K2 Snowplows part #K281511.

It is likely you can avoid the drain line when installing the MORryde X-Factor Crossmember for Standard Frame Hangers #MR33WR by using the MORryde X-Factor Crossmember Adapter Kit for Drop Down Applications #MR43WR. I don't know exactly the…

We have front suspension enhancement that fits your 2000 Ford F-150, but we do not have anything from SumoSprings. The only option we have is the Timbren kit part #TFF150972 which will fit and work well.

Hey John, thanks for reaching out! It all depends on what snowplow you go with. For example, the Agri-Cover SnowSport LT #SS98GV requires 8" - 14" of clearance under the receiver, while the Detail K2 Snowplow #K2AVAL8826 requires a hitch…

To install the Curt Hitch part #C31068 on your 2014 Ford F-150 with Ecoboost you will need to remove the air dam and then trim a small section of the lower fascia. See photo.

If you have a front hitch installed ono your 2018 Chevy Silverado 3500 then you would not need anything else to use the Detail K-Summit Plow part #K2SUMM8826ELT that you referenced. If you do not have a front hitch we have the Curt part #C31071 that…

Yes, you can use the Detail K2 Rampage II Snow Plow part #K2RAMP8219 on your 1988 Ford Bronco II with the correct custom install bracket kit part #K281100.

Hey Dean, so the install is super easy for the Agri-Cover SnowSport HD Utility Snowplow #SS48GV (which is what I assume you were looking at) - you just slide everything into your receiver and set the height. For the weight, it's not terribly…

Hey Dan! What are you experiencing when you tow your trailers? If you're getting rear sag with a little bit of body roll I would get the Coil SumoSprings #CSS-1168R for the additional suspension support. If you're primarily getting a lot of…