DIY 2018 Jeep JL Wrangler Installation for the Detail K2 Snowplow for 2" Hitches Video

Thank you for the photo. We may have a few replacement seal options for your Seal on 2001 SnoPro Clamshell Enclosed Trailer but you'll need to confirm the dimensions we have will work for what you're needing. The Rubber Large Half…

The Electric Jack w/ Footplate is offered both with the plug part #EJ-3527-BBX and without the plug part #EJ-3520-BBX. Therefore, if you wanted to go with the model that has the plug and just cut that off you would indeed just run the wire to the…

Fantastic photos thanks so much, and the short answer is it is very, very likely the skid plate on your 2022 Toyota 4Runner TRD Off Road will interfere with the Curt Front Mount Trailer Hitch Receiver #C31076. This model of 4Runner has a different…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…

I went ahead and reached out to my contact at DK2, and he said that you are correct in saying that you will have to remove the air dam on the bottom of the bumper of your 2019 Ram 1500 Classic in order to install the mounting brackets #K284314 on a…

The Draw-Tite Front Mount Trailer Hitch Receiver #65079 does fit your 2021 Jeep Gladiator as long as you do not have the Mojave or Rubicon models.

I am and almost 100% certain that you will not be able to use the Curt Front Mount Trailer Hitch Receiver #C31086 with your Blackhorese bull bar. We do not now or have previously ever carried the Blackhorse products to be able to test fit them with…

For your 1999 Toyota Tacoma the brackets you'd need are the #K285120 to use the Detail K2 Storm II Snowplow part #K2STOR8422 that you referenced.

I am happy to help you find the parts to flat tow your 2004 Jeep Wrangler. The Roadmaster Direct-Connect Base Plate Kit part #RM-521424-5 is a better option for a base plate compared to the Roadmaster #RM-521424-4 that you referenced because the…

The wireless remote of the K2 Detail plow part #K2SUMM8826ELT only controls the up and down function of the plow and now the angle from side to side.

I did some research and I got the following information. You will have to be careful plowing wet and heavy snow with the Detail K2 Snowplow for 2" Hitches - 82" Wide x 19" Tall, part #K2AVAL8219. According to K2, "Your K2 snowplow…