Result: reflectors

Hey Dylan - both M-3 plates measure 81-3/4 inches wide, so you'd need to trim off a little bit. The aluminum one #M348FR would be easier to trim, so I'd pick that over the steel one. The hinge runs the full width so you’ll still get solid…

Hey Rick. Unfortunately that's correct the Wesbar Tail Light 271594 has been discontinued. Our best option for replacing it is the LED Trailer Tail Light item #STL36RB for the passenger side and item #STL37RB for the driver side. The Wesbar light…

Hey Marcus! We actually do have the Tamper-Proof Door Latch w/ 36" Pipe for Enclosed Trailers #ABS39FR in black (I just asked for it to be added for you). It's available as Part #ABS29FR on our site. Are you looking to match a certain…

Hello Randy, thanks for reaching out. The offset would be measured from the center point of the wheel. For a dually wheel the best way to do that is to find the center point between the bead seats. I edited a picture to help illustrate. The #AM83NR…

The tow package wiring is located under the dash above where your left knee would be as you were sitting at the wheel. Look for a wiring harness with a white tag on it. GM no longer has a connector, you'd just need to wire the controller directly…

The Superwinch Winch 2 Go Portable Winch - Wire Rope - Hawse Fairlead - 4,000 lbs, part #SW1140222, has the following duty cycle 15 seconds on 5 minutes off. I have included a video demo link below.

The thickness of the tube is not any different as they are both 3 inch diameter, and the spindles are also the same utilizing the same inner diameter bearings, hubs, and seals. The difference in capacity is in the custom bend in the axle that creates…

The Dexstar #AM20789 Mini-Mod wheel and the Americana #AM20906 valve stem are indeed compatible with each other, but the center cap you referenced, part #LHCS102-SI60C is compatible with a 3.19 inch wheel pilot hole diameter, and wouldn't work…

Hey Craig, thanks for reaching out! I believe the Optronics Fleet LED Trailer Tail Lights w/ Grommets #TLL12RK will work as replacements for your 2008 Featherlite 4926 trailer, but you'll need to confirm this on your end. These lights carry the…

There is a flange on the Tandem Axle Trailer Fenders w/ Backing Plates #HP82VR that overlaps the backing plate that you'll use for the welding surface. When it comes to welding, we always recommend having this done by an experienced welder.

Hello Lance, thanks for reaching out. When replacing shackle straps and equalizers, the replacement parts must be identical in size to the original. Since your current shackles are 3.5" long, you will NOT be able to use the 2-1/4" shackles…

Since color coding on trailer wiring is different for almost every manufacturer you have two options for determining what wire goes where for wiring in a trailer connector. You can either trace the wires back and see where they terminate to determine…