LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Amber Lens

Video Transcript for Command Electronics Trailer Lights - Clearance Lights - 328-K-51 Review

Presenter: Today we're taking a look at a LED clearance or side marker light with a built-in reflex reflector. This small, oval trailer light serves as either a side marker light or a clearance light. It is a LED system. LEDs make great replacements for incandescent lights. They last longer, they burn brighter, and they're more efficient. With LEDs you don't have to worry about replacing bulbs and you don't have to worry about brittle filaments.Now this light has a nice amber lens with a built-in reflex reflector, mounts directly on the surface of your trailer, hardware not included and it can be mounted horizontally or vertically.

Whatever works best for your application. The holes are pre-drilled here in the base and to gain access to those you just need to pop the lens off and then once you install it, the lens snaps back on into position. It's a two wire pigtail so it includes your lead and ground wire. Ground is white. Power wire's yellow.

It does require at least a three quarter inch diameter hole here for the wire base to fit into to. So again, a three quarter inch diameter hole is required at the insulation surface for this area right here to fit into. You can see how that sticks out. And that would be for a flush mount or surface mount design. It is SAE-approved and it is a PT-rated light.Taking a look at the overall dimensions real quick, starting with the overall length measuring edge to edge.

Very close to four inches, maybe three and 15/16ths. Right in that area. The overall height or width, depending on how you have it installed, is one and five eighths. And then the overall depth, that's how far it sticks out from the installation surface, is a half inch. And then these mount holes are separated on center by two and a half inches.We're gonna go and hook it up to power.

That way you can see what it looks like with some power running to it. We'll also be able to turn off our overhead lights so you can see it in a lower light setting. So you can see here the light sends out a bright, consistent signal. This unit contains two LEDs or two diodes. So the multi-diode design really helps optimize the overall light output. And with the light turned on, you can get a really good look at that built-in reflex reflector that's built into the lens.And that's gonna do it for today's look at the LED clearance or side marker light with the built-in reflex reflector.