Brake Controller Installation on 2007 Chevy Tahoe

Question

Question:

how do match the brake controler wiers on an 07 tahoe

asked by: boyd

0

Expert Reply:

The tow package wiring is located under the dash above where your left knee would be as you were sitting at the wheel. Look for a wiring harness with a white tag on it. GM no longer has a connector, you'd just need to wire the controller directly to the tow package wiring.

The red tow package wire supplies 12-volt power, and connects to the black wire on your brake controller. The light blue tow package wire attaches to the red wire on the controller, the dark blue tow package wire connects to the blue controller wire, and the white tow package wire connects to the white controller wire.

We have an install guide online and an installation video that you might find helpful, I will provide links below. The install guide and video show the install on a Sierra or Silverado pick-up, but the procedure would be identical for your Tahoe.

If you haven't already decided on a brake controller, I can highly recommend the Tekonsha Prodigy P2, part # 90885. The P2 is very easy to use, which helps make it one of our most popular brake controllers.

expert reply by: Mike L

0

Answer 1

It appears the wiring to connect a Trailer Brake Controller #90195 on your 2024 GMC Yukon are going to be high up on your dash close to the left side of the drivers compartment. You can start by removing the left side panel of the dash which sits up…

view full answer...

Answer 2

Hey Tom, for your Tekonsha brake controller to install in your 2025 Nisssan Pathfinder you would want the install harness part #C51382 which plugs into the port under your dash. You would need to cut off the Curt side of the connector and wire it by…

view full answer...

Answer 3

Hi Brian! Yes, the Hydrastar Marine Electric Over Hydraulic Actuator for Disc Brakes #HS381-8067 is compatible with the OEM brake controller on your 2025 Ram 1500. The brake actuator works with Ram trucks 2010-Current. See the attached chart. What…

view full answer...

Answer 4

It looks like you have a Kwikee 24/25 Series Electric Step. In which case, if you need a new motor you'd actually want to go with the Replacement Motor with Gear and Table for Kwikee 24 and 25 Series Electric RV Steps part #LC369529. You…

view full answer...

Answer 5

Hey Rick, We do have the trailer wiring harness that fits a 2025 Honda Odyssey, which is the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56382. I did verify this fit with Curt, and then for the trailer hitch use the…

view full answer...

Answer 6

The Curt T-Connector Vehicle Wiring Harness part #56083 is correct for a 2022 Lexus RX 350 with factory tow package. It's a plug-in harness that does not require any splicing for installation. The plug you will need to locate to use this harness…

view full answer...

Answer 7

That is a good question but you will still need to take your 2020 Chevy Silverado 3500 to the dealer to have the computer flashed in order to add the Tekonsha Prodigy P3 Trailer Brake Controller #90195. The correct plug in adapter that will work for…

view full answer...

Answer 8

Assuming your trailer has brakes, you may still need a brake controller. GM started putting factory brake controllers in their trucks and SUVs in 2007, but it was an option. The factory brake controller did not come standard with the tow package. If…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Brake Controller Installation on 2007 Chevy Tahoe

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching