Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This fender light makes it easy to stay visible from both directions. The amber lens faces forward and the red lens faces rearward, covering both sides of your trailer’s fender with one compact unit. It’s built with a reflex reflector right into the housing, so there’s no need for a separate reflector to meet visibility requirements. With two 194 bulbs running on a 12V DC system, it puts out steady light for clear signaling day or night.
Installing this light is straightforward thanks to the surface-mount design and included bracket. The mounting holes are spaced 1-1/2" center to center, giving you a secure fit without extra drilling or modification. The pre-wired setup with a female barrel connector and grounding eyelet makes wiring quick and clean. Once in place, it sits neatly on the fender and stays put through regular use.
If your trailer ever sees rain or water spray, this light can handle it. The polycarbonate housing and lens form a durable, sealed structure that’s rated as submersible. That helps keep moisture out of the electrical connections so the bulbs stay protected when you’re on wet roads or near water.
The P2-rated beam pattern gives you 45 degrees of light to either side of center for a total of 90 degrees of coverage. That meets DOT standards for clearance lighting, creating a bright, visible marker that can be seen straight on from the front or back. It’s a dependable setup when you want consistent visibility in all lighting conditions.
When it’s time to change a bulb, you can pop off the lens with a flat screwdriver and access the two 194 bulbs without tools or special instructions. Each light draws only 0.4 amps at 12.8V, keeping current demand low while still giving bright incandescent output. It’s an easy-to-maintain setup that keeps you visible without complicated upkeep.
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews
I had a blow out on my trailer that took the fender which I replaced. Your marker lights were exactly what I needed so I purchased and installed both the left and right fender marker lights. Installation was easy. The heat shrink on all connections will insure that the lights will work for a long time.
This was a universal fit for both right and left fenders if you change the lights around. I choose to remove the lights in the housing and install my upgraded LED lights that I had on the trailer. The part matches the older broken one perfect.
This was a universal fit for both right and left fenders if you change the lights around. I choose to remove the lights in the housing and install my upgraded LED lights that I had on the trailer. The part matches the older broken one perfect.
Excellent product, quality, appeal, however, the plastic piece that protrudes out to cover the wires is about a 1/2" to short;it was not long enough for the lights to screw back into the right holes and cover up wire hole in fender. I used clear silicone to cover the part of the wire that was left uncovered.
Impressive size! Fits all the way to the outside edge of aluminum fenders for double axle enclosed trailer. Includes ground wire. Strongly recommend mounting with self locking nuts and bolts of stainless steel or chrome. Self tapping screws WILL work loose when mounted in aluminum sheet metal - guaranteed.
etrailer.com is a Superb Website to purchase good Trailer Parts.
I received Very Professional Service - coupled with quick shipping.
What more could I ask for?
Our local repair and parts store could not find the proper lights for my trailer from their online connections. I was confused after spending ten minutes looking on the web to find etrailer might have the lights I needed, because, other sites displayed the part, but actually were out of stock and no longer were continuing the item. Admittedly, I ordered with little faith and waited for an email telling me the part was discontinued. However, to my surprise, the part arrived on time as promised exactly as I needed. Needless to say I am VERY pleased with etrailer. For giggles, I intend sending a link to my local store for the obvious.
great service, great selection and fair prices... only way I could be happier is to have found etrailer.com 5 years ago.
D
NICE LIGHT
Driving to Alaska this summer I lost the tread on my 6'x12' cargo trailer in Canada destroying my drivers side trailer fender. etrailer sent a replacement up to me in Chugiak, Alaska that I installed for the drive back to Florida. The AlCAN Highway can be pretty tough on vehicles still today. I also needed to replace both trailer fender marker lights upon my return and had etrailer send me the exact ones I had lost on the trip. Almost 10,000 mile journey. Great prices, great service and fast /reasonably priced shipping. Extremely satisfied with etrailer in every way.
A well made product and easy to install with a few self tapping screws. Having the 2 ground wires pre-wired to a common ring lug made the installation that much easier.
John
8/30/2019
Just great. No issues.
I needed a new fender and running light for my Wells Cargo cargo trailer after I had a tire blowout that ripped by right side fender off. The fender was basically a direct replacement. The running light was slightly different but installation was fairly simple. Shipping was super quick and the price was reasonable. I have never had a bad experience when dealing with the folks at etrailer. I highly recommend them and their services. Thanks.
RIGHT PART, RIGHT PRICE
Really nice and sturdy assembly just love them very bright! Nicely done
The parts were a perfect match for the old ones on my trailer as rocks and age took it's toll. I would buy again as shipping was fast, parts were right and had no hassles. I bought 2 tail lights and 2 fender marker lights. Thanks for the great job guys! I will buy from you again as needed.
Robert
10/24/2019
Still in great shape with no problems!
Works great! Not possible to install until you buy the 8 point drive bit for the screws fastening it to the trailer .
I installed the new fender lights and they work great.
Nicer than the fender that came on my t railer.
Easy to find the exact part needed...Easy website transaction and quickly shipped and received. Thanks
I have a 2010 international trailer. I was unable to find exact match parts so I went to etrailer to find comparable parts. My previous lights sat in the middle of the fender. These sit on the edge so you get a true picture of your edges at night.
You guys are great, I will continue to order all of my trailer stuff from this company
Etrailer comes through once again! Fast order confirmation. Great communication on shipping and follow-up communication upon delivery. Couldn't ask for more! Great job!
Worked perfectly right out of the box. The etrailer install video was indispensable for a novice like me.
https://youtu.be/MSks5RqKoIE?si=28WsMJWevytE87zY
Claire H.
7/6/2026
I'm glad our video helped you out when installing this. It looks like you did an amazing job!
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Darrell M.
8/7/2015
Worked great, great service a great find