Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We have a folding trailer tongue hinge that could work for the purpose you describe, as long as your trailer frame isn't constructed of aluminum. You could use the Fulton Fold Away Coupler Hinge, part #FHDPW330300. The hinge kit is designed…
view full answer...I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
view full answer...The only way I can recommend a tongue extender for your trailer that has a 3 inch by 3 inch channel is to remove your current coupler, install the hinge kit part #FHDPW330300 in place of it and then install your coupler onto a length of 3 by 3…
view full answer...There is a way to determine the right replacement hubs for your older trailer, but I wasn't able to cross-reference your Hadco assemblies to another model using the 394 stamped onto the hub. Your best option is going to be to pull one of the hubs…
view full answer...Though we do have the replacement bearings, races, and seals available for your Hadco 3109 hub (which I have listed below), the combination used will not have an equivalent replacement hub available, unfortunately. Replacement Trailer Hub Bearing…
view full answer...The closest seal we have to what would match what you have would be the part #168255TB. This seal has an outer diameter of 2.561. The inner bearing with the matching ID would be the part #603049. Nothing we have would fit the 2.328 you have for the…
view full answer...To install the Fulton Fold-Away Coupler Hinge Kit for 3" x 5" Tongue #FHDPB350101 you will simply need to cut your current trailer tongue so that you have the desired length that is foldable (see attached customer photo). Because of this we…
view full answer...It sounds like you have a single axle trailer and are curious about whether or not to put the hanger like the part #28-5 or a shackle in front on the trailer frame. We recommend you put the hanger in the front. The force from the bumps in the road…
view full answer...If your 2003 Dodge Ram 2500 has a factory hitch that has an opening that measures 2-1/2 inch by 2-1/2 inches the Curt hitch extender part #C45048 will simply just slide into it. The 2-1/2 inch hitch size is pretty common on newer heavy duty trucks…
view full answer...There are a couple of things that you can do to get more ground clearance for your new trailer. First, if the leaf spring stack is attached under the axle then you could use an over/under conversion kit. If the trailer has a 2-3/8 inch diameter round…
view full answer...You can raise your trailer about 2 more inches using the Correct Track Trailer Alignment and 2" Lift Kit - Single Axle #LC87120. Then you can also add longer hangers if you prefer. We do have long hangers like #115919 which are the longest…
view full answer...If your Can Am Commander has a 2 inch hitch the hitch extender that would most likely work best for you would be the #HE18. This product has more than enough capacity for your spreader, but you should note that when you use a hitch extender like this…
view full answer...Filter Your Search
Contact and Help