Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
A lot of the older Atwood water heaters have been discontinued, yes. For your replacement I recommend the Atwood RV Water Heater #AT94022 which is a 10 gallon gas/electric unit like you currently have with an automatic pilot. This uses 120V power…
view full answer...The standard size lunette ring is 3 inches like the Demco Lunette Ring - Adjustable Channel Mount - 3" Diameter - Black - 25,000 lbs #DM09557-81. The 2-1/2 inch rings will not fit in the adjustable channel mounts where the vast majority of…
view full answer...Yes. The Replacement Motor and Gear Head Assembly for HappiJac Truck Camper Jack System #LC182515 is the correct replacement motor for your HappiJac Series 4220 #LC736514. This will replace both the motor and gear head assembly that has been…
view full answer...Yep! The 1-7/8" 12pt Thin Walled Socket #ALL643216 does work with the e2 Fastway round bar weight distribution systems. This socket costs considerably less than the Equal-i-zer socket and works just as well so it's what we normally…
view full answer...For a large socket that will fit the 1-7/8 inch nut on ball #19286 you can use #EQ70-00-4800.
view full answer...Part #EQ70-00-4800 is a 1-7/8 inch socket with an outer diameter of around 2-3/8 inches.
view full answer...Since most weight distribution (WD) systems use the same style of shank with the same adjustment hole locations and sizes you should be able to just use the Fastway e2 Weight Distribution Shank #FA92-02-4315 which gives a trunnion system a max drop…
view full answer...The non-threaded portion of the Replacement 2" Ball with Nut For Buyers Products Combination Pintle Hitch #337RB102000 is taller than most hitch balls but it has a diameter compatible with a lot of ball mounts as it's shank diameter…
view full answer...The max drop the #FA92-02-4315 that you referenced can do is 8 inches. Since you need right at 6 inches of drop to tow your trailer level this shank would work well for you. I attached a help article link on selecting the correct rise/drop ball…
view full answer...The nut on a hitch ball with a 1-1/4" diameter shank, like the B&W #BWHB94002, takes an 1-7/8" socket, like #ALL643216 (for use with a 3/4" drive socket wrench) for example. Hitch balls with an 1-1/4" shank…
view full answer...Using the Equal-i-zer Weight Dist Shank item #EQ90-02-4600 will not reduce your 2016 Ram 1500's capacity or limit your weight distribution hitch. This shank has a 600 to 1,400 lbs tongue weight range and will allow you to haul your trailer…
view full answer...I spoke directly with my technical contact over at Dexter. Basically you cannot replace an 8-430 hub with an 8-288 hub due to differences in the spindles that each of those hubs fit. If your axle was made after July of 2009 then you will need to…
view full answer...Filter Your Search