Recommended Bearing Kit for a 5,200 Pound Lippert LC152 Axle  

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it…

The answer is yes, rather than the Equa-Flex, the longer-lasting and better quality is the MORryde Shock Absorbing Suspension Equalizers for Triple Axle Trailers w/ 33" Wheelbase #MR59ZR. The rubber on the MORryde #MR59ZR won't last forever,…

Yes, the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger #PD9280A would be an exact replacement for your PD9280 converter. If you weren't just going to replace it and were going to troubleshoot the issue I recommend…

I would be happy to compare the Road Armor, Dexter E-Z Flex, and MORryde equalizers you were looking at for your Jayco Eagle 325BHS. First things first each of these kits are designed to replace equalizers that measures roughly 6" between the…

We do have the correct bearing kit, along with the spindle washer and nut for your Lippert 5,200 lb axles. What you need are the following: - Bearing Kit #BK3-300 - Trailer Spindle Nut #165686 & Washer #SW1000

As long as you are going to be backing up mostly in a straight line you can leave the spring bars of the Reese Dual Cam II part #RP75FR installed. If you are going to jackknife the trailer at all though the bars will need to be disconnected.…

The Equal-I-zer, #EQ37100ET, and Reese Strait-Line, #RP66084, weight distribution systems are both top notch systems that will get the job done for you, but I usually tend to lean towards the Equal-I-zer systems for a few reasons. First, Equal-I-zer…

The inner diameters of the LM67048 and 15123 both are the same (1.250 inches). That means that a hub with either bearing in the outer bearing would fit your spindle. The part #AKHD-655-6-EZ-K would fit your axle.

Thank you for the images. This shows me you currently have the Dexter Electric Trailer Brake Kit #23-105-106 on your 2007 Airstream Safari. I recommend upgrading to the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 as this will give you…

The 84 spindle takes a 3,500 lb hub like the #84545BX which uses bearings #L68149 and #L44649. This is a 10 inch drum. The 42 spindle takes a 5,200 lb hub like part #AKHD-655-6-EZ-K and uses bearings #25580 and typically #15123. This uses 12 inch…

I checked with Lippert and in regards to the Lippert Components High-Speed Power Stabilizer Jacks like part #LC369774, they recommend soap and water only for maintenance. I have attached a photo below with this information.

A #84 spindle is the standard 3,500 lb axle spindle. It uses an inner bearing L68149 (1.378" inner diameter), and an outer bearing L44649 (1.063" inner diameter). These days this is basically universal for 3,500 lb axles. What you have with…