Wiring Installation Into the Custer Light Mounting Box # AL65-02

Updated 08/29/2017 | Published 08/28/2017

Products Featured in This Question

Custer Light Mounting Box - (2) 6-1/2" Long Oval Holes - Diamond Plate Pattern - Aluminum

(2)

$68.45

Replacement Flush Mount Rubber Grommet - 3/4" Diameter - Qty 1

(59)

$4.69

3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead

(381)

$4.69

Right Angle 3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead

(647)

$7.99

PVC Grommet for 6-1/2" Oval Trailer Tail Lights

(966)

$5.27

Miro-Flex LED Trailer Light - Parking and Turn Signal - Submersible - Oval - Amber

(34)

$19.62

Miro-Flex LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red

(425)

$26.35

Snap Bushing Grommet - 7/16" ID, 9/16" OD

(76)

$1.30

Question:

I was wondering how you would present the wiring the AL65-02 light housing? Do you offer grommets or some type of bulkhead? Thanks

asked by: Henry W

Expert Reply:

For the Custer Light Mounting Box - (2) 6-1/2" Long Oval Holes - Diamond Plate Pattern - Aluminum # AL65-02, you will use the PVC Grommet for 6-1/2" Oval Trailer Tail Lights # A70GB with lights like # STL22RB or # STL22AB.

These lights use a pigtail like # A47PB or # A45PB. You will need to drill holes in the housing to mount and add a hole for the wiring as well. I recommend using a the Snap Bushing Grommet - 7/16" ID, 9/16" OD # SWC8055 or the Replacement Flush Mount Rubber Grommet # A11GB to protect your wiring.