See what our Experts say about this Kenda Trailer Tires and Wheels

• Which Trailer Tire Size is best for a Jet Ski Trailer that has 4.80-12 Tires
  Increasing tire width will not really benefit you in any significant way. You would see a slight increase in stability, but if the trailer already rides pretty straight, you may not see any improvement. The 5.30-12 tires would also make the trailer sit a bit higher. My suggestion would be to use part # AM30630. It is a galvanized wheel for 4 on 4 pattern. It is a load range C bias ply tire and each wheel would be capable of supporting 990 pounds at 90 psi, which should be more than enough...
  view full answer...
• How to Determine the Correct Over-Under Conversion Kit
  In order to determine whether you need the Dexter Trailer Springs Over-Under Conversion Kit # K71-384-00 (2-3/8") or # K71-385-00 (3") you will need to measure the diameter of your axle. If you get 2-3/8" then you need # K71-384-00 and if you get 3" then you need # K71-385-00. As far as tires/rims are concerned you will want to ensure you have a 4 on 4 bolt pattern (which is the most common 4 bolt pattern) I have included a link to an article that can help you with determining this. You...
  view full answer...
• Comparison of Two Kenda Tire and Wheel Combos Part # AM30670 and # AM30790
  Both tires # AM30670 and # AM30790 are Kenda tires but there are a number of differences. For starters they're different sized tires. The # AM30670 is a 4.80-12 sized tire and # AM30790 is a larger 5.30-12 sized tire. The latter being about 3/4 of an inch wider and over an inch larger in diameter. Also, they both have a C Load Range but the larger # AM30790 has a higher weight capacity at 1,045 pounds when inflated to 80 psi. The # AM30670 is rated up to 990 pounds at 90 psi. With...
  view full answer...
• 2011 Jayco Jay Series Sport Wheel and Tire Replacement Recommendation
  For a good highway wheel and tire with the size 5.30-12 I'd go with the Taskmaster wheel and tire part # TA26RR as this is a radial tire which does better at highway speeds.
  view full answer...
• Replacement Trailer Tire Recommendation for a 2004 Bass Tracker Panfish Boat Trailer
  It sounds like you are overloading your current trailer tires or are pretty close to and should upgrade to a 5.30x12 tire with enough capacity. For that you would want the # AM10068 which has a capacity of 1,250 lbs at 105 psi per tire. Special trailer tires should be inflated to their maximum air pressure. If a trailer tire is inflated to a lower air pressure than the maximum, the amount of weight that the tire can carry will be reduced. If a heavier load is put on the trailer tire than...
  view full answer...
• Recommended Wheel/Tire Combo W/ a 4 on 4 Bolt Pattern
  Dave, we do have a tire/wheel setup similar to the Kenda K353 Bias Trailer Tire # AM10068 with the Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel # AM30790. This wheel measures 12" diameter x 4" wide, has a 4 on 4 bolt pattern, and come with the Kenda bias ply tire that has a C load range.
  view full answer...
• Availability of Galvanized Wheel and Tire 5.30-12 with Higher Speed Rating
  Hey Scott, the only way to accomplish what you are looking for is to order the wheel and tire separately. For that you'd want the part # TT53012C for a tire that matches the size you need and has the higher speed rating of 81 mph plus the wheel part # AM20124. Now I wish we had the ability to mount tires here but that's not an option we have at this time so you would need to find a shop local to you and have them mount the tires.
  view full answer...
• Does the Center Pilot Hole on a Trailer Wheel Have to Be an Exact Size to Fit Over the Hub
  There are 2 different types of wheels you will find on a trailer: lug-centric and hub-centric. If your wheels attach to the hub using lug nuts then it is lug-centric. This means that the wheel centers on the hub using the lug nuts. If your wheels attach to the hub with wheel bolts and no lug nuts then it is hub-centric and the wheel centers on the hub using the center pilot hole. If you have the first type, lug-centric, then the pilot hole can be larger since it centers on the hub using...
  view full answer...
• Availability Of a 12 x 4 Inch Wheel With 4 Lug Bolt Pattern and 5.30-12 Inch Trailer Tire
  Currently all the wheel and tire combinations we have with the 5.30-12, and a 4 lug bolt pattern are going to have a 2.84" pilot hole center. This should not be an issue for mounting as these are all lug centric wheels which will center on your hub using tapered Lug Nuts # CE11051 and not the hole center. Here is a list of the wheels and tires we currently have for the dimensions you are needing. Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel - 4 on 4 - Load Range C # AM30790 Kenda...
  view full answer...
• 5.30-12 Tire and Wheel Options for a 2006 Rockwood Forest River Freedom Pop-Up Camper
  We currently have 10 different tire and wheel options for a 5.30-12 size. There are 2 different bolt patterns, so you would need to determine if you have a 4 on 4 or 5 on 4-1/2 bolt pattern. I have included a help article that helps with figuring that out and I have included the options for each bolt pattern below. 4 on 4 - Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel # AM30790 - Kenda 5.30-12 Bias Trailer Tire with 12" White Wheel # AM30780 - Kenda 5.30-12 Bias Trailer Tire...
  view full answer...
• Can Bigger Tires and Wheels be Used on a Aluminum Jet Ski Trailer with 145/12 Tires
  You might be able to use a larger tire as long as there is space all around the existing tires for the larger size. The next size up from your 145/12 size is going to be 175/80-13. This tire size will be 1.3 inches wider and 2.8 inches taller. What this means is you will need more than 0.65 inches between the sides of the tires closest to the trailer and the trailer itself. And you will need more than 1.4 inches from the tops of the tires to anything above them, such as fenders. If you...
  view full answer...
• Can 4.80-12 Tires Be Upgraded to 5.30-12 Tires
  The 5.30-12 tires, like the Kenda Bias Trailer Tire # AM30790 you were looking at, have about a 1-1/2" larger diameter than your 4.80-12 tires, so if your fender can accommodate 3/4" more tire and still retain 2" of height clearance (to account for suspension travel) you'll be good to go!
  view full answer...
• Recommended Lug Nut Torque Rating on 2,000lbs Trailer Hub Assembly # 34822BX
  I was able to go back and see that the part number you ordered was the # 34822BX. For the 8-14 inch wheel size with the coned lug nuts you will want to torque them down to 75-85 ft lbs.
  view full answer...
• Can a 145R12 Tire Replace a 4.80x12 Bias Trailer Tire Size
  The closest radial tire size I would have to replace the 4.80-12 bias tire size is the Kenda Karrier S-Trail ST145R12 Radial Trailer Tire # AM10130. The 4.80-12 bias tire is 20.7 inches tall and 4.9 inches wide. The 145R12 radial tire is 21.3 inches tall and 5.7 inches wide. If you have clearance for a little more than 1/2 inch height and a little more than 3/4 inch width you can use the 145R12 radial tire size. Both of the tires will mount to a 12 x 4 inch wheel. A radial tire will give...
  view full answer...
• What PSI Should Trailer Wheel and Tire be Inflated to In Size 5.30-12
  Sounds like maybe you have more than one brand of tire on your trailer and there is multiple PSI requirements based on that. It is correct that you should always run the max pressure in the tire listed on the sidewall otherwise capacity is diminished and likelihood for failure is increased. For a wheel and tire in your size of 5.30-12 and a wheel bolt pattern of 4 on 4 like you need the part # AM30790 would be a really great option.
  view full answer...
• Can 10 Inch Trailer Wheel/Tire Combo Be Replaced With 12 Inch On Jayco Trailer
  You said you have a 4 on 4 wheel bolt pattern on the wheels you have on your trailer with the 20.5X8-10 tires. The overall diameter of that tire is 20.5 inches. The Kenda Tire/Wheel Combo, part # AM30790 has a 5.30 - 12 tire on a 12 inch wheel and measures 21.9 inches diameter, and has a 4 on 4 bolt pattern as well. . If you have sufficient clearance under the trailer when adding the 12 inch wheels and tires, you will be fine. I have attached a helpful article about measuring the...
  view full answer...
• Speed Rating for Kenda 5.30-12 Bias Trailer Tire with 12 Galvanized Wheel - 4 on 4 # AM30790
  Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel - 4 on 4 - Load Range C Item # AM30790 is rated for 65 miles per hour.
  view full answer...
• Recommend Upgraded Tire/Rim Combo From A 5.30-12 Tire
  When it comes to upgrading your 5.30-12 tire I would recommend upgrading them to The Kenda Karrier ST145/R12 Radial Trailer Tire with 12 inch Black Mod Wheel - 5 on 4-1/2 - LR D # AM35354. This radial tire has a ply rating of 8 and has a 1,220 pound maximum load capacity at 65 psi. The 12 inch by 4 inch wide steel trailer wheel has a 5 on 4-1/2 inch bolt pattern and is corrosion resistant with its black powder coat finish. The tire has a maximum speed rating M which is up to 81 mph....
  view full answer...
• Trailer Wheel and Tire Options for Size 5.30-12 on 4 Lug Trailer Wheel
  Based on the numbers you listed what you have is a trailer tire size 5.30-12 Load Range C on a 12 inch trailer wheel with a 4 on 4 inch bolt pattern. For a combo that covers all of that aside from being a radial we have the # AM30780 for a white wheel or part # AM30790 for a galvanized wheel. None of the combos we offer in this setup have a radial option For just the tire we have the part # TT53012C which will work well and is a radial. Then for a wheel to match this we have the part #...
  view full answer...
• Wider Tire Recommendation for Waverunner Beach Launches with a Loadrite Trailer and 2010 Toyota Rav4
  It may be possible to use a wider tire and wheel combination on your trailer to help with launching on a beach. You will need to determine if the overall width and height of the replacement assembly will work on your traielr and not rub the frame or fenders. The Kenda 165/65-8 Bias Trailer Tire with 8 inch White Wheel, item # AM3H200, may work for your application. this combination is 16-1/2 inches overall diameter and 6.6 inches wide. Measuring your trailer for clearance will tell you...
  view full answer...
• Tires & Wheels for 86 Jayco Pop Up with 2.75 Pilot Hole & Wheel Bolts
  There may be a solution but I do not have 8” or 10” wheels with 2.75” pilot holes. They are all 2.5” pilot holes. I have 12” wheels with 2.84” pilot holes. For example, Kenda # AM30790 is a 5.3 X 12” trailer tire with a 2.8” pilot hole, load range C and 65 mph. Kenda # AM30780 is a 5.3 X 12” trailer tire with a 2.84” pilot hole, load C, 65 mph. Kenda # AM3H370 is a 205/65-R10 trailer tire with a 2.5” pilot hole, load C and 81 mph. If you were using lug nuts (instead of bolts) then only...
  view full answer...
• Can Trailer Tire Size 20.5x8.0-10 be Upgraded to Taller Size
  In the 10 inch wheel size the 20.5x8.0-10 that you have is the tallest size overall at 20.5 inch. If you wanted to bump up to a 21.9 inch overall diameter tire you could go to a 5.30-12 tire with something like the # AM30790 if you have a 4 bolt pattern or # AM30820 if you have a 5 bolt. This would be a narrower tire as well so there wouldn't be any risk of clearance issues with the trailer frame.
  view full answer...
• Recommended Axle for 3 Foot Wide Dog trailer
  For a 3 foot dog trailer you probably need an axle that is 40 inches from hub face to hub face and has the spring locations that match with your frame. We have an axle-less system that is ideal for your type of application and it includes the suspension needed. I recommend the Timbren Axle-Less Trailer Suspension System with Hubs - 4 on 4 - Regular Tires - 1,200 lbs # A12RS440 which includes the hub assemblies and is compatible with wheels that have a 4 on 4 inch bolt pattern. For your...
  view full answer...
  
• My Boat Trailer Has 5.30-12 Tires But The Rim Measures 13", Is This Correct?
  It sounds like you are measuring the outer diameter for your wheel. On a Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel # AM30850 the diameter of the wheel is measured at the inner diameter of the bead seat and will typically be about 1" narrower in diameter than the outer diameter. This particular wheel and tire has a 5 on 4-1/2" bolt pattern. We do have a similar option with a 4 on 4" Bolt Pattern # AM30790 depending on your hubs.
  view full answer...

Do you have a question about this Trailer Tires and Wheel?