Result: t63fr

Hey Ryan, The Demco Hydraulic Brake Actuator #DM72VR is approximately 18-1/8" long and 6" tall (9-1/4" if you include the height of the breakaway lever).

The Replacement Master Cylinder Assembly #T4395100 will not work to replace your Atwood master cylinder model 85841. Since replacement parts for your actuator are obsolete, your only option is to replace the entire actuator assembly. The Demco…

Replacement parts for an Atwood actuator are going to be very hard to find these days. Atwood stopped producing actuators quite a while back, so at this point unless you can find parts secondhand, replacing the actuator is going to be your best bet.…

To replace your old Atwood surge brake actuator I recommend the Dexter DX7.5L A-60 Brake Actuator - Weld On - Drum - 2" Ball - Primed - 7,500 lbs #DEX94FR which will still work with your 2" hitch ball and drum brakes. You will have no…

The closest option we have to replace your Atwood 82543 actuator is part #DM72VR. However, it doesn't have the lockout like your Atwood does. To add a lockout use #T4748800 but it's an electric lockout unlike the Atwood's manual lockout.…

The Demco Hydraulic Brake Actuator part #DM72VR is a great option to replace an Atwood 82543. That said, it does not come with any sort of reverse lockout feature therefore in order to reverse without the brakes locking up you will either need to add…

For a Lippert 4,400 lb trailer axle the correct bearing kit is the part #BK2-100 which includes inner bearing #L68149, inner race #L68111, outer bearing #L44649, outer race #L44610, grease seal #58846, a cotter pin and a tang washer.

To replace a spindle, the old one would need to be cut off, and the new one welded into place. This is NOT a job for the do-it-yourselfer. The new spindle must be absolutely square with the axle in order to prevent premature tire wear and wheel…

There are 2 wires that are coming out of the actuator in the Titan Disc Brake Kit #T4843300. You will want to connect one to the 5-Pole connector on your trailer and ground the other one using a Ring Terminal #DW05737-1; it doesn't matter which…

The Dacromet-Coated brake calipers included with the Titan #T2HRCM10DAC Premier Disc Brake Kit do indeed feature stainless pistons and guide bolts. The exterior of the caliper and the rotors are Dacromet coated for corrosion resistance.

Hey David, The Dexter DX7.5L A-60 Brake Actuator w Electric Lockout #DX56FR accepts brake lines with 3/16" male inverted flare fittings with a 3/8"-24 thread size like the DeeMaxx Hydraulic Brake Line #DE38GR.

According to my research, the Titan Aero 7500 and the 6000 Brake Actuating Couplers both use the same bolt pattern. To confirm this, you can compare the dimensions of the diagram I produced for you with the bolt holes on your trailer tongue.…