Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey George. The Power Mountain Tallboy Off-Road Bottle Jack item #PM34FR is only rated for 6-tons but it's not like you're raising up the entire motorhome. Most of the weight is going to be on the back though and since it is a dually, I…
view full answer...Hey Mike. For a 5th wheel trailer that long, I recommend using two of the MORryde I-Beam Mounted Stabilizer item #MR96RV. Mounting one of these in the front a few feet back from your landing gear and then one in the back is going to take care of any…
view full answer...The tow package wiring is located under the dash above where your left knee would be as you were sitting at the wheel. Look for a wiring harness with a white tag on it. GM no longer has a connector, you'd just need to wire the controller directly…
view full answer...Hi Shawn! I am surprised they do not include a more heavy duty hitch on the 2025 Jeep Wrangler Rubicon 4-door. I would have thought it would at least be a little closer to the vehicle's capacities, but car companies have done strange things for…
view full answer...I've attached a dimensional drawing for the Ark XO Drop Down Corner RV Stabilizer Jacks #ARK87FR, which displays the measurements in mm and inches. If you need anything else please let me know and I'd be happy to help.
view full answer...I went out to the warehouse and pulled Pins and Thumb Clips #EQ95-01-9415 to measure them for you. The diameter is 3/8 of an inch. The usable length is just under 2-1/2 inches (2.45 inches). And the opening is 2.46 inches by 1.5 inches.
view full answer...When you go to the Torklift Magnum hitch part #TLF1002-30 you will need to also replace the rear Torklift tie downs with the part #TLR3504 as the tie downs you have now will not fit with the new hitch.
view full answer...The only other extension option we carry besides the Torklift SuperTruss extender that does not cut your tongue weight in half is an extra long ball mount. Traditional extensions such as part #C45796 cut the tongue weight capacity of the hitch on the…
view full answer...For your 2012 Ford F-350, the TorkLift Hitch I recommend is part #TLF1002. This is a Class V hitch and has dual 2 inch receiver openings. The hitch also has pre-drilled holes that can accept TorkLift camper tie-downs. I have attached a link to our…
view full answer...Sure thing David! You're going to need the following parts for your 2012 Ford F-450: Torklift Hitch #TLF1002 48" Extension #TLE1548 (This is only rated for 6,000lbs without a weight distribution hitch, so to tow your 8,000lbs trailer…
view full answer...I do have an option for you but we don't really have anything specifically for this purpose and much of determining compatibility will be up to you. That said, I think your best option for stability would something like the Stallion Stabilizer…
view full answer...I would use two of the side vents part #PLR20 on either side of the trailer close to the middle so that it can vent the trailer equally front to back.
view full answer...