Video Transcript for Review of MORryde Camper Jacks - I-Beam Mounted Stabilizer - MR96RV

Hi everyone, Steven here with etrailer.com. Let's take a look at our MORryde I-Beam Mounted Stabilizer for your fifth wheel of travel trailers. So folks, you've done it many times. You stepped inside of your whole rig after you've set up camp, you feel like you're just shifting back and forth. Sometimes your drinks lost in their cups, people wake up in the middle of the night to use the bathrooms, and now you're waking up because everything is back and forth rocking and just jarring and everything. Every single movement is like a ripple effect through the floor.

So that kind of wobble is gonna wear on you after a while, it's gonna be irritating and you're not gonna get much sleep. Well, this will put an end to that. This is the I-Beam Stabilizer by MORryde. And what it's gonna do when it's installed properly is give you two down angle legs, if you will, that kind of go down, sit flat on the surface, and then they have a strap between them to keep them from kind of sliding left to right as well as an extra stabilizer. And they're gonna give you confidence and solidness underneath your camper.

So these will decrease rocking immensely and they kind of, like I said, sit at an angle, one on each side and they will attach to the I-Beam of your camper trailer. And they are adjustable, you can simply pull this spring loaded clip out. You have all these adjustments on this one pole. So it looks like one, two, three, four, six, seven holes. And then you would just adjust that however you need to as far as what specific angle you need to reach on that I-beam.

And then you'd put your pin back in place. And then obviously from there you may have to, you know, spin the angle to where now the foot is touching the ground solid. You do that on both sides. Then you take this included simple strap, ratchet strap, you put that on one side of each of them in the middle and that kind of pulls them down and locks them into place. And you even get a nice travel bag here that's weatherproof and that's gonna keep everything nice and clean in one spot.

You can just throw it inside your toolbox or compartment or something. There's no drilling or welding required. The brackets simply slide onto the outer lip of that I-Beam, giving you a super fast install. And again, that ratchet keeps the trailer planted in place. Now this is made for fifth wheels and trailers with I-Beam frames and it fits rigs with open I-Beams. And you need 12 inches of clearance below the frame. So if you had that 12 inches of clearance below the frame, this would be able to come down enough to give you stability again, one on both sides of that camper. And like I said, whenever you're done, you're ready to leave the campsite, you just simply close everything back down, pop your pins back in place so that way you don't lose anything, and then you can take your bag here and you can put everything right back inside for easy storage until the next time that you're out camping. So this really is a great product. It is simple, but it really does a great job. The installers here have been doing a lot of these on different campers here locally and everything, and the customers love them. So again, it's a simple thing, but it works. And this is our look together at the MORryde I-Beam Mount Stabilizer. I'm Steven, thanks for watching.