I checked with Polar Manufacturing and can confirm the center to center mounting hole distance on the Hood Latch with Mounting Bracket part #PLR284 is 1-7/16". I have attached a drawing of this for you as well.
We have all types of lighting and other specialized products for horse trailers like your 1995 Featherlite. I linked our main page for horse trailer products and also our specific page for clearance lights. We have both standard incandescent bulb and…
If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…
I'll try to start this answer off with some of the most important information- the batteries. The batteries you will need to power all of this would need to be 12v deep-cycle batteries with enough amp hour rating to power all of the tools and…
I pulled up the owners manual of your 2014 Ford F-150 and it looks like fuse number 67 is the trailer running light circuit so that would be the one you would need to check. It takes a 20 amp fuse.
I attached a picture that shows how 6-ways are typically wired. Looking at your picture it doesn't look like the colors will match up and you will need to wire by function instead of by color. Most likely the missing circuit on your 6-way wiring…
Thank you for reaching out and providing a photo! To install that same style of light on the CE Smith Single Axle Trailer Fender #CE17900G I recommend checking out the Incandescent Trailer Fender Light w/ Reflector which comes as part #BA44FNL for…
The male thread of the Replacement Adapter Fitting #T4871700 being longer would not be an issue when installing it in the back of the Dexter actuator part #K71-650. Pressure from the male side flare fitting to the actuator is what seals it so the…
The base of the B&W Turnoverball King Pin Adapter #BWGNXA4000 is 2-1/2 inches by 2-1/2 inches square. This adapter was specifically designed to fit in a B&W Turnoverball gooseneck trailer hitch. I have linked the above mentioned product to…
The measurement of the Replacement Hitch Ball for B&W Turnoverball Underbed Gooseneck Hitches - 2-5/16" #BWGNXA2000 is 2-1/2 inches by 2-1/2 inches by 4 inches. The ball on top of this shank is 4-1/16 inches tall. The hitch pin hole is…
B and W offers a king pin adapter designed to fit their Turnoverball hitches like the part #BWGNRK1108 that you referenced. For that you'd want the part #BWGNXA4000. You should note that this is for inverted fifth wheel setups and not standard…
Yes, the pop-in style gooseneck trailer hitch balls are cross compatible between the different factory puck systems from Ford, Ram, GM, and Nissan. For this, we have a few options such as the Curt Pop-In Ball part #C60629 which has a rise built-in or…
Filters
