Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Your coach is hooked up or the trailer's loaded, but the lights aren't working and there is no time to fix wiring. This wireless, battery-powered kit mounts with magnets and gives you stop, turn, and tail lights without a permanent install.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steven here with etrailer.com. Today, we're looking at our Optronics Wireless Magnetic LED Trailer Lights. Now folks, these are battery powered and it's gonna give you your stop tail turn and you do have a nice transmitter and wiring included. So again folks, these do require eight AA batteries and I went ahead and pulled one of these bases off. But basically you have the magnetic base, they've got this sticker you just peel off when it's time to use it for the first time, or you can leave it on as well and it works just fine to prevent scratches.
But basically, you'll push in these two plastic keepers on both sides, and I went ahead and took this one out already, 'cause they are kind of difficult to pop out the first time. This side has the on/off switch to tell it to work with the transmitter, but basically, you'll pull this out and it does, again, require the use of eight AA batteries in total, four for this light, four for the other light. So, if you can kind of see two on the top, two on the bottom, and then that just gets pushed right back down to place. It'll snap in place with this little keeper. And then, of course, you just put your base back on, pop it in place, and you're ready to go.
So again, the one side has the on/off switch, the other side does not. And then of course you have your transmitter here, it's magnetic as well. And that would wire up and just plug in here on the trailer connector. And then you have your wires to finish wiring it up to the trailer if, or you know, your plugin harness at the back of your tow vehicle rather as needed. Now these measure four and a half inches across, roughly two and three quarter inches thick because the base is the thickest part, and I got seven and a half inches tall overall from the base to the top here.
So again, folks, these are great for temporary use. If you're flat towing or when your trailer lights just stop working for whatever reason, you have a nice backup set. And again, they're sealed LEDs so they're gonna shine bright and clear and be resistant to water, dust, and debris. Well folks, that will wrap up our quick look together at these magnetic wireless Optronic LED trailer lights. I'm Steven with etrailer.
Thanks for watching.
I just put batteries in and tried them out a few minutes ago, nothing works!
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Nick S.
12/22/2025
I am sorry to hear these lights are not working for you. We will reach out shortly and help get this resolved.